HiB Breeze 31200 Посібник - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник для Вентилятор HiB Breeze 31200. HiB Breeze 31200 4 сторінки. Wall mounted fans
Друкувати сторінку
Fitting
1)
Choose a suitable position for your fan
according to Figure 1 on the back page.
Use a cable finder to check if there are any
buried cables or pipes in the wall. Draw
around the outside of the fan to determine
its exact location with a pencil. Mark the
position of the centre of the fan on the
wall.
2)
Drill a hole to mark the centre point using a
10mm drill bit. You should ensure that this
hole is angled slightly downwards. Using
the drilled hole as a centre point mark the
extractor opening on the outside wall.
3)
Use a 10mm bit to drill a series of holes
at 35mm intervals round the edge of the
circle that was previously drawn. Use a
60mm bolster chisel and club hammer to
chop out the waste.
4)
If necessary, use a chisel and hammer to cut
grooves in your internal plasterwork to take
the cable and conduit.
5)
Fit flexible ducting into the hole, flush
with both sides of the wall. Ensure the
duct slopes slightly downwards towards
the outside. Make good any plasterwork
around the duct.
6)
Position the fan back into place, and mark
the four fixing points. Drill the required
holes in the marked positions. If drilling
through tile, use a ceramic drill bit. Insert
wall plugs into the drilled holes.
7)
Follow a similar procedure for the outside
wall grille.
2
Electrical Connection
Hush
Please ensure that the fan unit is positioned in
accordance with the diagram below i.e. With
the electrical access point (5) top left.
4
5
1
1
Casing
2
2
Fan propeller
3
Function module
4
Protective cover of terminal block
5
Electrical access point
Breeze
6
2
4
3
1
Casing
2
Retaining clip for power lines
3
Holes for fan mounting
4
Terminal block
5
Electrical access point
6
Wire fixing rack
Fascia removal
Hush
- Depress plastic nodule on the side of the
fascia and gently prise away from the casing.
Breeze
- In order to remove the fascia for
maintenance, please remove the small retaining
screw and gently prise the fascia away from the
casing.
3
3
5