DAYTEK Laundry Quick Lock Fold Down Clothesline Інструкція з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Побутова техніка DAYTEK Laundry Quick Lock Fold Down Clothesline. DAYTEK Laundry Quick Lock Fold Down Clothesline 4 сторінки.

DAYTEK Laundry Quick Lock Fold Down Clothesline Інструкція з монтажу
Figure 3.
1. Thread line through
tensioner and pull tight.
OPERATING YOUR CLOTHESLINE
This clothesline uses a Lift & Lock mechanism. To raise the
clothesline, hold the FRONT BAR with hands spaced evenly. Lift
above the horizontal (1) and push towards the wall (2). Release
your grip and the clothesline will be locked into place.
To fold down the clothesline, lift the FRONT BAR and pull outwards.
This will unlock the clothesline and allow you to lower it.
15 YEAR PRODUCT WARRANTY
Our goods come with guarantees that cannot be excluded
under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and for
compensation for any loss or damage. You are also entitled
to have the goods repaired or replaced if the goods fail to
be acceptable quality and the failure does not amount to a
major failure.
If any part of this clothesline fails to operate correctly
due to faulty workmanship or defective material Daytek
Manufactured/Supplied by Daytek Australia Pty. Ltd.
77-81 Gower Street, Preston
Victoria 3072 Australia
T +61 3 9470 1755
F +61 3 9470 5381
daytek.com.au
2. Loop line around tensioner knob 2-3 times.
2
Australia will repair or replace free of cost within 15 years from
the date of purchase. (Receipt of purchase required). The PVC line
cord is covered by a 2 year warranty from the date of purchase.
Any evidence of misuse or incorrect adjustment will void the
warranty. To claim a product warranty, please contact Daytek
Australia directly. You must bear the cost of claiming the warranty.
This warranty is in addition to other rights and remedies of the
customer under law.
For further warranty information please visit www.daytek.com.au
3. Lock line into clip and trim
excess leaving approximately
50mm.
1