Daytime BC16 Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Контролер Daytime BC16. Daytime BC16 12 сторінок. Single-channel for matrix
Друкувати сторінку10. Brief overview of the settings
Setting
Time
Start of sunrise and sunset
(the hour)
Brightness
Daylight and night light
(0 – 100%)
Start of pause (full hour)
End of pause (full hour)
Transition period
(6 stages)
Factory settings
Time-lapse
Press and hold S1. Select the hour with S2 and the minutes with S3 (in 5-minute
increments).
for example: 20:15: press S2 20 times (= 20:xx); press S3 3 times (= XX:15)
Always set the hours before setting the minutes, since the minute value is set to 00 after
the hours are set!
Your settings will be saved automatically after a short interval of no pressed buttons.
Press and hold S1 for about 8 seconds until the status LED illuminates red. Then
release S1. Use S2 to select the number of hours for the sunrise start, and S3 for the
sunset start.
for example: Press zero times = 00:00; press 6 times = 6:00; press 21 times = 21:00
You must always specify both of these time points. However, if only one time point is
changed, the other time point will automatic be set to 0:00!
Press S1 to apply/save settings
Simultaneously press S2 and S3 to select day/night light. Dim with S2 (-); brighten
with S3 (+).
Apply/save with S1. Or settings will be saved automatically after a short interval of
no pressed buttons.
Press and hold S2 until the status LED turns red. Then select hours with S1.
for example: Press zero times = 00:00; press twice = 02:00.
Your settings will be saved automatically after a short interval of no pressed buttons.
Press and hold S3 until the status LED turns red. Then select hours with S1.
for example: Press zero times = 00:00; press five times = 05:00.
Your settings will be saved automatically after a short interval of no pressed buttons.
Press S2 briefly five times. LED displays red "blink code". Buttons S2 and S3 for
selecting one of the 6 stages:
1x blinking = without transition time / 4x blinking = transition time approx. 15 min
2x blinking = transition time approx. 1min / 5x blinking = transition time approx. 30min
3x blinking = transition time approx. 5min / 6x blinking = transition time approx. 60min
Press S1 to apply/save settings
Disconnect power supply > Press and hold S2 + S3 > Connect power supply > Status
LED flashes rapidly alternately red/green > Release buttons
Note: When the factory default settings are loaded, the internal clock is set to 00:00 hours
and must then be correctly set to the real time.
Press S1 quickly 5 times in succession to enable/disable the time-lapse function.
The status LED flashes alternately red/green when this function is enabled.
Procedure