Hibiscus Citizen CLP 8301 Інформаційний посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Інформаційний посібник користувача для Принтер Hibiscus Citizen CLP 8301. Hibiscus Citizen CLP 8301 2 сторінки. Replacing print head

Друкувати сторінку

10. Before printing, calibrate the printer for the resistance value of the new head.

WAR I G: failure to complete this step may impair print quality and/or shorten the life of the new head.

a) Switch on the printer whilst holding in the [Exit] key (release when display goes to 'CHECKING HEAD').

b) When printer is in 'READY' state, press the [Mode] button.

c) In Setup Mode, press the [Down] key until you get to 'FACTORY SETUP', then press [Select].

d) Press the [Down] key until you get to 'HEAD RESIST', then press [Select].

e) Display now shows two sets of numbers. Press [Down] until you find the range that encompasses the head

resistance value you noted down earlier (ie. lower number is less than and higher number is greater than head

resistance). When you find the correct range press [Select].

Press [Exit] once to return to 'FACTORY SETUP'.

g) Press [Down] until 'SAVE SETTINGS' then press [Select].

h) Press [Down] to underline 'YES' then press [Select].

Press [Exit] until 'READY'.

11. Now switch the printer OFF and back ON (without holding any buttons).

12. Operation is complete.

For technical support on printer issues call 0113 2424272 and ask for IT Support

Hibiscus PLC, Hudswell Road, Leeds LS10 1AG

HIBSOFT INFORMATION GUIDES

Citizen CLP 8301 – Replacing Print Head

Page: 2