HiBoost F10G-5S-LCD Посібник користувача - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник користувача для Подовжувач HiBoost F10G-5S-LCD. HiBoost F10G-5S-LCD 18 сторінок.

14. Kit 3-50400

Omni 3dBi Antenna & 50' 400 Coaxial Cable

15. Kit 3-75400

Omni 3dBi Antenna & 75' 400 Coaxial Cable

16. Kit 3-100400

Omni 3dBi Antenna & 100' 400 Coaxial Cable

17. Kit 32-50400-50

2 Omni 3dBi Antenna & 50' 400 Coaxial Cable & a 50 Ohm 2-Way Splitter

18. Kit 33-50400-50

3 Omni 3dBi Antenna & 50' 400 Coaxial Cable & a 50 Ohm 3-Way Splitter

19. Kit 34-50400-50

4 Omni 3dBi Antenna &50' 400 Coaxial Cable & three 50 Ohm 2-Way Splitter

TROUBLESHOOTING

The LCD screen displays the status of the booster on each frequency. When there are

not "ALC" and "ISO" indication, the device is operating normally meaning that it is

not experiencing any oscillation (feedback) and it is boosting the signal at maximum

gain. When the "ALC" and "ISO" is flashing, it means that particular frequency is

experiencing some oscillation (feedback) or too strong signal from tower.

If the oscillation is excessive the booster will shut down for that particular frequency.

The booster will still work for the other frequency on a multi-band booster.

Oscillation is caused when the indoor (distribution) antenna sends a signal back into

the outdoor (signal) antenna. Similar to a PA system, when the microphone gets too

close to the speaker it causes feedback. This will occur if your antennas are too close

together, or the indoor antenna is pointed at the outdoor antenna. Make sure you

have adequate separation and some type of shielding between the antennas (Usually

your roof or a cement wall is good enough).

IMPORTANT NOTES

The 2 most important things to look for when setting up your system is:

A good input signal (the best you can find)

Isolating the outdoor (donor) antenna from the indoor

(server) antennas so they do not feedback into each other.

By capturing the best input signal you will be able to enjoy the maximum coverage

and best quality signal inside where your Indoor antennas are located. The better the

input signal, the better the output signal. In order to find the best input signal, you

want to place your outdoor antenna as high as possible with the least amount of

obstruction between the antenna and the cellular base tower. A clear line of site is

ideal.

Isolating the signal from the antennas is done by ensuring that the antennas are not

pointing to each other and by having enough distance or barrier shielding in between

https://www.signalbooster.com/ | 1-855-846-2654 | [email protected]