DaytonAudio CS620W Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Спікери DaytonAudio CS620W. DaytonAudio CS620W 4 сторінки. Contractor series

Друкувати сторінку

Congratulations on the purchase of your Dayton Audio

These speakers were manufactured with high quality components and engineered to deliver superior

sound performance. Like many of the products sold by Dayton Audio

designed for ease of installation. Please read through the instructions completely before you begin

your installation.

1) Parts Inventory

Your In-Wall kit should include the following:

• 1 pair of Dayton Audio

• 2 metal retroﬁt brackets

• 1 package of hardware

• 1 pair of cardboard mounting/paint masking templates

2) Installation Tools

The Dayton Audio

• Pencil

• Masking tape

• Drill & drill bits

• Utility knife

• Keyhole saw*

* Recommended for use if installing in plaster walls.

** Optional tools to make the installation easier.

3) Speaker Location

To achieve the best performance from your Dayton Audio

speakers, it is important to carefully select the location for

installation.

Your in-wall speakers should be installed 5 to 8 feet apart

to ensure proper stereo imaging. If possible, mount each

speaker the same distance from the corners on a common

wall. Keep the speakers at least 2 feet away from the corners

of the room to avoid overemphasized bass reproduction.

The speakers should be located so that the tweeter height

is at the same level, or slightly above the listener's ear.

You must now decide whether the primary listening will be done standing or in a seated position.

Remember, for the best stereo imaging, the listening position should be directly in-between the

speakers with the tweeters at ear level.

4) Speaker Installation

Once you have selected

the location for your speak-

ers, you are now ready to

install them.

CAUTION: Be certain

that there are no

electrical wires, water

pipes, or heating ducts

in the planned installation area before you start drilling or cutting into the wall. If there is an

electrical outlet nearby, turn off the circuit breaker to avoid possible injury.

The in-wall speakers are designed to be mounted to the wall area between the studs. Once you

have selected your location, the next step is to be sure you are between the studs. By tapping on

the wall, you will hear a hollow sound when between two studs and a sharper, more solid sound

when right on top of, or close to a stud.

An easier, more accurate method for ﬁnding the location of wall studs is to use a stud ﬁnder.

Once you have established that your chosen location is between two studs and that there are no

obstructions in the wall, tape your speaker template to the wall and lightly trace around the inside

opening with a pencil. To ensure that your speaker template is straight, you may want to use a level

before you mark the wall.

Drill a 1" hole in the center of the template outline. Next, using a piece of stiff wire (a coat hanger

works well), bend it 8" from the end at a 90 degree angle. Insert the bent part of the coat hanger

into the 1" hole and rotate the wire in a complete circle to check for obstructions. If the wire hits

a stud on either side, reposition your template to the left or right and re-do the light pencil outline.

Keep the pilot hole within the template outline.

In-Wall Speakers with Grills

In-Walls can be installed with the following simple tools which you supply:

• #2 Phillips screwdriver

• Wire cutters & wire strippers

• Small level**

• Stud ﬁnder**

Contractor Series In-Wall Speaker System.

, these in-wall speakers were