Automatic Solutions 603 Інструкція з монтажу Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Домофонна система Automatic Solutions 603. Automatic Solutions 603 12 сторінок.

Друкувати сторінку

Re-coding Handset/Adding Extra Handset

Occasionally a system may need re-coded once installed. If the handset does not ring when the

call button is pressed, it may need re-coded. The procedure for doing this is the same as for

adding an additional handset as follows...

Transmitter PCB

1.Press and HOLD

for 3 seconds

Once the melody is heard, the handset should then be working. The system should now be ready

for testing.

Press the call button on the intercom and all coded handsets should ring (max 4 handsets).

Answer the call on any handset by pressing

volume while on a call with up and down arrow buttons on the handset and press the same button

again to end the call. The gate/door release button can be pressed at any time, either while on or

off a call. The relay on the transmitter should then pulse on for 4 seconds.

Using the intercom Handset

P a g e

| 10

Testing

Calling.....

Relay 2

Answer /

end call

Change

ring tone

Select or enter

Handset

12.21

and check for good 2 way speech. Adjust

12.21

Relay 1

Internal call

another handset

Up and down arrows

increase / decrease ring

and speech volume

2.Press and HOLD for

>6 seconds until 3

tone melody is heard

12.21