Automatic Technology GDO-11V3 Ero Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Відкривач гаражних дверей Automatic Technology GDO-11V3 Ero. Automatic Technology GDO-11V3 Ero 20 сторінок. Overhead garage door opener
8. Coding Transmitters
8.4 Operating PET (Pedestrian) Mode
a. Briefly press the DOOR CODE button three (3) times,
then press it again and hold (the opener will beep
four times on the fourth press.
b. Choose a transmitter button not already coded into
the receiver. Press and hold this button for two (2)
seconds, pause for two (2) seconds, then press the
same button again for two (2) seconds and release.
c. Release the DOOR CODE button.
d. Press the transmitter button to test.
8.5 Operating the Courtesy Light
Although the courtesy light comes on with each
operation of the opener, it may also be controlled by a
transmitter without operating the door.
a. Press and hold the DOOR CODE button four
(4) times, then press it again and hold (the
opener will beep five times on the five press
(Fig.
8.3).
b. Choose a transmitter button not already coded into
the receiver. Press and hold this button for two (2)
seconds, pause for two (2) seconds, then press the
same button again for two (2) seconds and release.
c. Release the DOOR CODE button.
d. Press the transmitter button to test.
8.6 To Erase Programmed Codes
a. Select the transmitter you want to delete.
b. Press and hold the DOOR CODE BUTTON.
c. Press the transmitter button you would like to
delete for two seconds, pause for two seconds,
press again for two seconds and then release.
Release the DOOR CODE BUTTON.
should now be deleted. Confirm this by pressing the
transmitter button - the function (e.g.
should not respond.
8.7
Remotely Coding Transmitters
Using this method transmitters can be coded without
access to the opener's control panel as long as a
pre-coded transmitter is available.
a. Take any pre-coded transmitter. Press the button
for the function to be duplicated and release.
b. Using a small needle / pen, press and hold firmly
for two seconds the middle button, through the
(Fig.
Coding Hole
The code
door opening)
8.4).
GDO-11V3 Ero
TM
Home Owner's Manual
Press DOOR
CODE button
four times then
press and hold
Fig. 8.3
Fig. 8.4
c. Within ten (10) seconds take the additional
transmitter you wish to code. Hold the new
transmitter's button for two seconds, pause
for two seconds, hold again for two seconds
and then release.
d. Wait for ten (10) seconds and then press the
new transmitter's button to test.
11
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the courtesy light