Automatic Technology GDO-6 EasyRoller Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Відкривач гаражних дверей Automatic Technology GDO-6 EasyRoller. Automatic Technology GDO-6 EasyRoller 20 сторінок. Rolling door openers
Також для Automatic Technology GDO-6 EasyRoller: Інструкція з монтажу (2 сторінок), Короткий посібник з експлуатації (6 сторінок)
Друкувати сторінку
8. Coding Transmitters
Press and hold
LIGHT CODE
button
Fig. 8.3
Button
Fig. 8.4
Fig. 8.5
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the courtesy light
®
GDO-6 EasyRoller
8.4 Setting the Transmitter to Operate the
Courtesy Light
Although the courtesy light comes on with each
operation of the opener, it may also be controlled by a
transmitter without operating the door.
a. Press and hold the LIGHT CODE button. The LIGHT
CODE LED will illuminate and the courtesy light will
turn on to indicate that the light code learning is active
(Fig.
8.3).
b. Choose a transmitter button not already coded
into the receiver. Press and hold this button for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds
and release.
c. Release the LIGHT CODE button.
d. Press the transmitter button to test.
8.5 To Erase Programmed Codes
a. Select the transmitter you want to delete.
b. Press and hold the DOOR CODE BUTTON
(Fig. 8.4).
c. Press the transmitter button you would like to
delete for two seconds, pause for two seconds,
press again for two seconds and then release.
Release the DOOR CODE BUTTON.
should now be deleted. Confirm this by pressing the
transmitter button - the function (e.g.
should not respond.
8.6
Remotely Coding Transmitters
Using this method transmitters can be coded without
access to the opener's control panel as long as a
pre-coded transmitter is available.
a. Take any pre-coded transmitter. Press the button
for the function to be duplicated and release.
b. Using a small needle / pen, press and hold firmly
for two seconds the middle button, through the
(Fig.
Coding Hole
c. Within ten (10) seconds take the additional
transmitter you wish to code.
transmitter's button for two seconds, pause for
two seconds, hold again for two seconds and then
release.
d. Wait for ten (10) seconds and then press the new
transmitter's button to test.
Home Owner's Manual
The code
door opening)
8.5).
Hold the new
11