Greatneck 26006 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Викрутка-шуруповерт Greatneck 26006. Greatneck 26006 15 сторінок.

Друкувати сторінку

RIGHT/LEFT SWITCH

The cordless screwdriver is equipped with

a convenient switch that functions as both

an ON/OFF switch and a right/left switch.

To drive screws, press the upper part

of the switch (1) (Fig. 3). To turn the

switch OFF, release the switch.

To remove screws, press the lower

part of the switch (2).

SCREWDRIVER LIGHT

The cordless screwdriver is equipped with

an LED light (1) (Fig. 4). The light will

automatically turn ON when the switch is

pressed. It will also turn OFF when the

switch released.

Fig. 4

ASSEMBLY & OPERATION

Fig. 3

PREPARING SCREW HOLES

It is important to prepare screw holes

before attempting to fasten two pieces of

wood together. Proper preparation will

make screws drive easier and prevent

misaligned components, stripped screw

heads, splitting and separating of wood

components.

Clamp components that are to be

screwed together in their desired

position (Fig. 5).

Drill a pilot hole (1) through the outer

piece (2) and into the inner piece (3).

Drill hole 2/3 the diameter of the

smooth portion of the screw shank.

NOTE: If the wood is soft, drill the hole

2/3 the length of the screw. If the wood

is hard, drill the hole the full length of

the screw.

Remove the clamp from the two pieces

to be screwed together.

Enlarge the hole (1) in the outer piece

(2) so it is the same size as the

smooth portion of the screw shank

(Fig. 6).

If using a flat head screw, counter-sink

the hole (4) so the head of the screw

will be flush with the surface when fully

driven into place.

Fig. 5

Fig. 6