DayTronic PC-HSICA Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Мережеве обладнання DayTronic PC-HSICA. DayTronic PC-HSICA 13 сторінок. High-speed serial interface card

Друкувати сторінку

ETUP OF

For setting protocol values for an instrument's COMPUTER INTERFACE PORT,

see the respective instrument manual.

Every conventional serial driver has provisions for setting the interface protocol

for the COM PORT whose number has been assigned to the PC-HSICA (Section

2.a.3). For example...

2.e.1 V

1. From Windows, run the TERMINAL program.

2. Select Communications... from the Settings menu.

3. In the window that appears, select for "Connector" the COM PORT whose

number has been assigned to the PC-HSICA card (Section 2.a.3).

4. Now specify the desired Baud Rate, Data Bits, Stop Bits, Parity, and Flow Con-

trol parameters.

5. Click on the OK button and exit the TERMINAL program.

2.e.2 V

While in DOS, you can use the MODE command to reset protocol for the PC-

HSICA interface. For example, to set the protocol to 153.6K baud, 7 data bits, 2

stop bits, and NO parity for a PC-HSICA that has been assigned to COM1, you can

enter a command of

—or to set the COM2 protocol to 9600 baud, 8 data bits, 1 stop bit, and EVEN pari-

ty, you can enter

The BASIC OPEN COM statement can be used in a similar way. Thus, to set the

protocol to 153.6K baud, 7 data bits, 2 stop bits, and NO parity for a PC-HSICA

that has been assigned to COM1, you can write a command of

—or to set the COM2 protocol to 9600 baud, 8 data bits, 1 stop bit, and EVEN pari-

ty, you can write

2.e S

2-6

ETTING

PC-HSICA C

INDOWS ®

DOS

C:>MODE COM1:150,n,7,2

C:>MODE COM2:9600,e,8,1

100

OPEN "COM1=150, N, 7, 2, CS, DS" AS #1

100

OPEN "COM2=9600, E, 8, 1, CS, DS" AS #1

NTERFACE

ROTOCOL

OMMUNICATIONS

TERMINAL

BASIC C

OMMAND

INE