Automatic Technology Australia GDO-8 v1 EasyRoller II Інструкція з монтажу Посібник з монтажу - Сторінка 18

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Відкривач гаражних дверей Automatic Technology Australia GDO-8 v1 EasyRoller II. Automatic Technology Australia GDO-8 v1 EasyRoller II 20 сторінок.

Друкувати сторінку

SYMPTOM

Door will not operate.

Door starts to close but automatically

reverses to open position.

Door operates from drive unit (OPERATE)

button but not from transmitter.*

See note.

Door will not open or close fully.

Door is overshooting or not reaching limits. Datum position not set correctly.

Cannot set limits.

Door not working with PE installed.

*Please Note: Some areas may be prone to excessive radio interference brought on by devices such as cordless telephones, wireless

stereo headphones and baby monitors. It is possible that these devices could cause a degree of interference such as to greatly reduce

the range of the transmitter. In such an instance please contact your ATA dealer for an alternative frequency replacement kit. As this is

not a warrantable situation but an environmental issue charges may apply for the changeover.

DATE

Please Note: Failure to maintain your garage door may void the warranty for your garage door opener.

TROUBLE SHOOTING

Mains power not switched on.

Door is obstructed.

Door is locked or motor jammed.

Door tracks/hardware damaged.

Adverse weather conditions (wind or cold)

causing door to stiffen and become tight in

the tracks.

Possible obstruction in the doorway.

Transmitter code not stored in memory.

Flat Battery.

Door limits position need to be reset.

Datum position not set correctly.

PE Beam or wiring faulty

PE Beam not aligned correctly.

PE Beam is obstructed.

Door obstructed when closing.

MAINTENANCE PERFORMED BY

POSSIBLE CAUSE

REMEDY

Switch on mains power.

Remove obstruction.

Unlock door or remove jam.

Door requires service/repair by qualified

technician.

Increase force margin setting See Step 8.3

on page 13. Or re-calculate force margin.

See Step 8.6 on page 13.

Remove obstruction.

Code transmitter in to openers memory.

Refer Step 9.1 on page 14.

Replace battery - A23 Alkaline 12V.

Reset limits position. See Page 12.

Reset datum position. See Step 6.2 Page 11.

Set datum position. See Step 6.2 Page 11.

Repair PE Beam or replace wiring.

Re-align optics. See PE Instructions.

Remove obstruction from the path of PE.

Remove obstruction.

SIGNATURE

AMOUNT

INV. No.