Dynalabs DYN-C-1000-DE Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Вимірювальні прилади Dynalabs DYN-C-1000-DE. Dynalabs DYN-C-1000-DE 8 сторінок. 2g/4g/8g/10g/20g/40g/50g/100g/200g/500g
Друкувати сторінкуAll rights reserved. Reproduction or issue to third parties in any form whatsoever is not permitted without written authority from the proprietors.
3) Operation and Installation
3.1) General
The general sensor connector configuration is given below;
Cable Code/Pin Configuration:
• Red : V +
• Black : Ground
• X : Yellow : Signal(+)
Blue : Signal(-)
WARNING
Never connect the power supply and/or the power ground to yellow and/or blue
cables.
Never connect the power supply to the power ground. Always use a clean power
source and check the voltage range.
4)
Sensor Static Calibration Verification
Using gravity, voltage values are measured in the + and - directions, providing a value of 1 g.
The measurement should be made as follows;
When the acceleration value of 1000DE series sensors is entered
to the data aqcuisition system, the sensor shows +1 g
with the effect of gravity in the direction of the arrow sign.
When the sensor is positioned in the opposite direction
of the arrow as shown below, it shows -1g
under the effect of gravity.
Using gravity, the voltage values that provide 1 g in the + and - directions are measured and
compared with the catalog value. The calibration value should be close to the catalog value with
a 10% tolerance. Sensor catalog sensitivity values are given in Table 1.
Power supply voltage +6 to +40 VDC
Power GND
Positive, analog output voltage signal for differential mode.
Negative, analog output voltage signal for differential mode.
7