GReddy Turbo Kit Emanage Ultimate Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари GReddy Turbo Kit Emanage Ultimate. GReddy Turbo Kit Emanage Ultimate 18 сторінок. 2003 mazda rx-8 (13b-msp) t618z 10cm2 (actuator type)
Друкувати сторінку
2. Factory Parts Removal
When removing the stock parts, please refer to the factory RX8
Workshop manual for proper procedures.
2-1 Factory Parts Removal
1. Remove the engine cover and the battery cover. Disconnect the negative terminal of
the battery.
2. Remove the battery, battery box, and battery tray.
3. Drain the engine oil.
4. Remove the front strut bar, air cleaner box, air cleaner insulator and intake pipe.
5. Remove the engine under cover, front inner fender, and front bumper.
6. Remove the Front Stabilizer Bar.
7. Remover the AIR pump, AIR Control Valve, and AIR Control pipe.
8. Remove the Transverse Member.
9. Disconnect the rear o2 sensor and remove the Cross Member, and Catalytic
Converter.
10. Disconnect the front O2 sensor and remove the Right Engine Mount Bracket, Right
Engine Mount Rubber and exhaust manifold using the SST tool to hold the engine.
(RX8 Workshop Manual pages 01-13-2 ~ 01-13-6)
(RX8 Workshop Manual pages 09-10-7)
(RX8 Workshop Manual pages 01-16-2, 01-16-2, 01-16-8)
(RX8 Workshop Manual pages 02-13-18)
(RX8 Workshop Manual pages 01-15-2)
(RX8 Workshop Manual pages 01-15-2 ~ 01-15-4)