Automation Correct Coal-trol Digital TS2 Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Терморегулятор Automation Correct Coal-trol Digital TS2. Automation Correct Coal-trol Digital TS2 16 сторінок. Automation correct coal-trol digital – model ts2 thermostat

Instruction Manual
Safety Information - Read and pay careful attention before proceeding!
ATTENTION – Please follow all manufacturers instructions that came with your stove or furnace.
The Coal-Trol Digital OEM1 is designed to complement and enhance the safe operation of your
appliance. Specifically, the Coal-Trol Digital control system ihas been supplied with appliances
tested to ANSI Standard Designation: E1509–95 , Standard Specification for Room Heaters,
Pellet Fuel-Burning Type and/or UL1482 Room Heaters, Solid Fuel Type.
Use of the Coal-trol Digital™ on appliances not permanently marked with one of the above
designations voids all warranties and may be unsafe. Contact us or your stove manufacturer if you
are not sure that your stove/furnace is built in compliance with these safety standards.
WARNING – The Coal-trol Digital™ is capable of regulating a coal fire smaller than required to
maintain proper chimney draft. Follow all manufacturers recomendations for minimum draft
pressures and temperature. Installation of a carbon monoxide detector (not-included) is highly
recommended.
This safety information printed on the cover of the Coal-trol Digital™ Power Module:
Other Important Safety Information:
TO REDUCE RISK OF ELECTRICAL
SHOCK, DO NOT CONNECT TO A CIRCUIT
OPERATING AT MORE THAN 150 VOLTS
TO GROUND
RISK OF ELECTRICAL SHOCK: THE CONTROL MODULE
Automation Correct LLC
Coal-trol Digital™ – Model TS2 THERMOSTAT
THIS PRODUCT HAS A GROUNDING TYPE PLUG AND
REQUIRES A GROUNDING TYPE OUTLET. IF THE PLUG
DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN.
DO NOT MODIFY THE PLUG IN ANY WAY.
FOR INDOOR USE ONLY.
AND THERMOSTAT HAS NO SERVICEABLE PARTS
INSIDE. SEE WARRANTY FOR SERVICE.
WARNING: BYPASS OF POWER VENT FUME SWITCH
OR BONNET TEMPERATURE LIMIT, IF INSTALLED, IS
DANGEROUS. OPERATION MAY CAUSE SEROUS
INJURY OR DEATH, DUE TO COx POISONING OR FIRE.
6/2006 R0
Page 3
www.automationcorrect.com