Automation Direct CLICK PLUS Series Посібник із швидкого старту - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Контролер Automation Direct CLICK PLUS Series. Automation Direct CLICK PLUS Series 11 сторінок.
Друкувати сторінку
Connecting via USB
To connect the CLICK PLUS CPU to a PC, use a USB A
to USB micro-B cable, such as the AutomationDirect
USB-CBL-AMICB6 cable.
1.
Connect the cable between the CPU micro-B port and an
available USB port on your PC.
CLICK Plus
PLC
USB B
Port
USB Cable
ADC Part #
USB-CBL-AMICB6
2.
Once connected open the Software and select the PLC Menu
and Connect.
3.
In the Connect to PLC Window, select USB for Port Type.
4.
For Com Port No., select the COMX (CLICK PLUS).
LOAD A PROJECT
The CLICK PLUS CPU is now ready to continue
configuration using the CLICK software and load a project.
Copyright© 2020, Automationdirect.com Incorporated/All Rights Reserved Worldwide
C2-02CPU Quick Start Guide
PC with
USB A Port
External Features
WLAN/BLE External Antenna Port
Status LEDs
Mode SW
micro USB
(Device)
Power
Terminal
Block
CPU is shown with op�onal C2-FILL Op�on Slot Cover installed.
LED Status Indicators
BLUETOOTH LED (Blue)
WLAN LED (Green)
Blink
On
Link
Blink
Activity
Blink
Blink
No Link
Off
POWER LED (Green)
On
Power Good
USB Low
Blink
Power Mode
Off
Power Failure
RUN LED (Green)
On
CPU Run Mode
Initializing
Blink
Analog Module
CPU Program
Off
Mode
ERROR LED (RED)
Self Diagnostic
On
Error
Self Diagnostic
Blink
Warning
Off
No Error
www.automationdirect.com/click-plc
3505 HUTCHINSON ROAD
CUMMING, GA 30040-5860
1-800-633-0405
Ba�ery
(Op�on)
Expansion
Connector
Op�on Slot
(for Op�on Slot Module)
On
Link
Activity (per packet)
Pairing Mode
(500ms flash)
Disabled in PLC
(200ms flash)
No Link
Off
C2-02CPU
C2-02CPU
7