Celestron 21037 Посібник з швидкого налаштування

Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Телескоп Celestron 21037. Celestron 21037 20 сторінок.

Q U I C K S E T U P G U I D E

E N G L I S H

Unpack your telescope and verify that all parts are present. Your

PowerSeeker 70EQ includes: an optical tube; tripod; equatorial

mount; latitude adjustment screw; star diagonal; 2 eyepieces; a

3x barlow lens; finderscope; 4 lb. counterweight; counterweight bar;

two slow motion control cables; and an accessory tray.

4 4

Check to ensure that all three legs are the same height once

extended to provide a level platform for the telescope.

7 7

Locate the equatorial mount and place the base of the mount

through the hole in the center of the tripod mounting platform.

70EQ

#21037

2 2

To set up the tripod, spread the legs outward until they are

fully extended and push down center leg brace.

5 5

Place the eyepiece accessory tray on top of the tripod's center leg

brace. Thread the tray into the the threaded hole in the center of the

leg brace until it is fully seated.

8 8

From underneath the tripod mounting platform, thread the attached

mounting bolt into the hole on the bottom of the equatorial mount.

3 3

Extend the center portion of each of the three tripod legs down

about 6 to 12 inches. Use the tightening screw on each leg to secure

the extended leg in place.

6 6

If necessary, rotate the accessory tray counterclockwise until

the accessory holes are not covered by the leg brace arms as

shown here.

9 9

Look up the approximate latitude of your observing site on the

Internet or using a map. Then, thread the latitude adjustment screw

into the equatorial mount until your latitude is indicated on the

latitude scale.

E NG LISH | 1