Dynalink 56K e-modem II Посібник з швидкого налаштування - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Мережевий маршрутизатор Dynalink 56K e-modem II. Dynalink 56K e-modem II 6 сторінок.
Друкувати сторінку
The Internet
When following Step 4, the modem is not listed under "Modem Properties".
This error can occur when the drivers have not been installed correctly.
Click Start – Settings - Control Panel – System – Device Manager
Check under Other Devices. If there is a reference to a modem, highlight it then
click Remove.
Click Refresh. Windows should re-detect the modem and ask for the drivers.
NO DIALTONE is reported.
Check that the country selection is set to Australia or New Zealand as appropriate
(see Step 3).
Click Start – Settings - Control Panel – Modems – Properties – Advanced. Under
Extra Settings, enter X3.
Eliminate any cables or devices between the phone cable and the wall jack, such
as fax switches or extension phone cables.
Windows does not detect the modem.
Check the modem is powered ON - the green PWR LED should be lit. If the LED
does not light, check you are using the 12V 1A AC Power Supply Unit that shipped
with the modem and that it is plugged into an active power point.
Check the serial cable is firmly attached to your PC and modem.
Verify the modem's COM port is enabled in the BIOS - if you are not familiar with
your PC's BIOS, contact your PC dealer.
When clicking the More Info button, an error is reported.
Check you have clicked on the COM port your modem is attached to.
Check the serial cable is firmly attached to your PC and modem and is turned on.
Ensure no other programmes are using the modem - exit all programmes before
running More Info.
Manual selection of connect rates is required.
AT&U1 turns modem into V.34 (33600 bps) mode
AT&U returns modem into V.90 mode
If other rates are required, refer to Chapter 5 of the manual on CDRom. The command
to use is AT*I. This command should be used in conjunction with &U.