Dynalink RTA020 Посібник з швидкого налаштування - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Мережевий маршрутизатор Dynalink RTA020. Dynalink RTA020 6 сторінок.
Друкувати сторінку
DIAG
Diagnosis
LAN
Network Link
DSL
Link Status
DATA
Data Status
V. Reconfigure router after reset to factory default
If it happens that router has been reset to factory default, restore the NZ
configuration you will require to connect. Go to Configuration > WAN > ATM
PVC > Setup ATM PVC:
On - Power is on.
Off - Self-test OK.
Blinking – Software upgrade in progress.
On - Self-test failed.
Off - Ethernet not present.
Blinking – data going through port.
On - Ethernet is present.
Slow blinking - handshaking in progress.
Quick blinking - training in progress.
On - Linked to DSLAM at exchange.
Off - No data.
Blinking – Sending or receiving data.
Next go to Configuration > Advanced > IP Static Routing > Setup:
To save configuration, follow Step 5 of Section II.