Dynalink RTA1320 Посібник з швидкого налаштування - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Мережевий маршрутизатор Dynalink RTA1320. Dynalink RTA1320 7 сторінок. Adsl2+ modem router
Також для Dynalink RTA1320: Технічні характеристики (3 сторінок)

Друкувати сторінку

Setting up Wireless (This only applies to RTA1025WE wireless router)

Wireless support is activated by default. Wireless security features are disabled for ease of install. It is

essential to have some form of wireless security enabled after you have veriﬁed that wireless

stations can communicate with the router. As a minimum, have Access Control enabled to deny access

from unwanted wireless stations.

A full description on this topic is found on Chapter 4 – Wireless in User's Manual.

SETUP PROCEDURE

Connect via the Ethernet port from a computer to conﬁgure wireless operation.

Start your web browser. Enter the default address http://192.168.1.1 The User name and

Password are both admin.

Click on Wireless > Basic. You can use any SSID of your choice. Pick a desired channel. If there

are other access points nearby, choose a channel that is not in use to avoid interference.

Wireless clients will scan all channels and use the same channel as the access point. Click Apply

Set up wireless clients according to the vendor's instructions. The router is also a wireless

access point. Every wireless client should use the same SSID as the access point.

To verify that a wireless station is connected, Click Status > Wireless Clients.

The table will display the MAC addresses of all connected wireless clients.

Enable a suitable level of wireless security and/or access control. At the minimum, have Access Control

enabled to deny access from unwanted wireless

stations. See Wireless Security below.

For more information on how to set up wireless please refer to our online step by step videos for this

model here: http://www.dynalink.co.nz/cms/index.php?page=how-to

WIRELESS SECURITY

Hide SSID, SSID is a name given to an access point to identify the network. Users may change SSID

anytime. By default, SSID is periodically broadcasted by the access point to advertise its presence.

In enabling the Wireless > Basic > Hide Wireless Network option, SSID is not broadcasted. Other

wireless clients within range normally do not ﬁnd the access point.