Gainbridge GT3088 Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для GPS Gainbridge GT3088. Gainbridge GT3088 17 сторінок. Magnetic & portable gps tracker with
Друкувати сторінку
4. Installation Manual
4.1 SIM Card Pre-installation, specification note
a. GSM Sim Only
b. SIM card should have its GPRS function enabled.
c. SMS request will function only if Caller ID function is enabled.
d. If SIM card is locked via PIN, please unlock SIM.
4.2 SIM Card Installations and Removal
a. MAKE A NOTE OF THE SIM SMS PHONE NUMBER
b. Open waterproof rubber
c. Insert SIM card into the SIM slot, metal face up, clipped corner to the right.
d. Green light is flashing for couple second and turn to on always on
e. Call the device SIM number and it is supposed to get through without answer.
f. Ensure the waterproof rubber is closed after SIM installation
5. What to do to make the device be online
5.1. Get a GSM card, only 2G GSM card can work with this tracker.
5.2. Check with the service provider and get the APN for the SIM card.
5.3. Set the APN to the device.
Send SMS to the SIM card in the tracker: *apn*xxx* ("*"is included)
5.4. Register the master controller.
Send SMS to the SIM card in the tracker: *master*123456*+1XXXXXXXXXXXX*
Note: +1 is the country code, xxxxxxxxx is the phone no. which will receive alert or message
from the tracker, you can replace it with your own mobile phone no.
5.5. Set the uploading interval.(refer to part 10)
Send SMS: *routetrack*99*
Or SMS: *check*0-99*
Or SMS: *checkm*10-999*
5.6. Log in the tracking web: gps.gaintrace.com with user name and password.
The user name is the registered phone no.
For example:
If your master controller no. is +55 12345678910
Then your login account would be: 005512345678910
Default Password: 123456
6. Operation Commands Guide
6.1 Set APN
(VERY IMPORTANT AND MUST BE DONE 1ST)
For the device to send data to the server, this command MUST be enabled.
SMS:
*apn*AXXX*BXXX*CXXX*
refers to user name, CXXX refers to password.
If there is no user name and password required, send as
If there is user name but no password required, send as
APN information can be checked on local telecom website.
, this command sets the telecom Access Point Name. BXXX
6 / 17
*apn*AXXX*
*apn*AXXX* BXXX*