HID Signo 25B Посібник з інсталяції - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з інсталяції для IP-контролери доступу HID Signo 25B. HID Signo 25B 2 сторінки. Biometric reader/controller
Також для HID Signo 25B: Посібник з монтажу (2 сторінок), Посібник користувача (18 сторінок)

Друкувати сторінку

Optional features

Open Collector Output – Controls an external device (5 VDC) operating in Host Mode only. Sink 40 mA /

Source -1 mA.

Optical Tamper – If connected via the pigtail wires, the optical tamper will sink to ground from the default of

5 VDC when the reader is removed from its backplate.

Relay Output – Typically used to control a strike lock. Three contacts are available on the pigtail wires

(common, normally open, and normally closed).

Wiegand Reader Interface – There is Wiegand output available, as marked on the pigtail wires.

Configuration options are available within HID Biometric Manager™.

Specifications

Input Voltage (V DC)

12V DC

Standby Current AVG

800 mA

Max Current AVG

1.5 A

Peak Current

2 A

Operating Temperature

-4° F to 150° F (-20° C to 66° C)

Standby AVG - Root Mean Square current draw without a card in the RF field.

Maximum AVG - Root Mean Square current draw during continuous card reads. Not evaluated by UL.

Peak - highest instantaneous current draw during RF communication.

Regulatory

Connect only to a Listed Access Control / Burglary LPS power supply. These readers are intended to be

used with listed (UL294) control equipment. Suitable for outdoor use.

Only Wiegand and Bluetooth communications have been evaluated by UL.

The Open Collector Output has not been evaluated by UL.

RS485 communications has not been evaluated by UL.

Inputs (reserved for future use) have not been evaluated by UL.

The Ethernet connection is for supplemental use; the unit is connected to an Access Control Panel.

The Signo 25B Biometric Reader is compatible with HID Mobile Access® version 3.3.1 and later using

mobile devices with BLE version 4.2 and later listed at:

https://www.hidglobal.com/mobile-access-compatible-devices

Install in accordance with NFPA70 (NEC) Local Codes, Canadian Electrical Code CSA 22.1, and authorities

having jurisdiction. Follow all National and Local Codes.

UL 294 Performance Levels

Access Control

Model #

Line Security Level

25B

Level I

CE Marking

HID Global hereby declares that these proximity readers are in compliance with the essential requirements

and other relevant provisions of Directive 2014/53/EU.

Por el presente, HID Global declara que estos lectores de proximidad cumplen con los requisitos esenciales

y otras disposiciones relevantes de la Directiva 2014/53/EU.

HID Global déclare par la présente que ces lecteurs à proximité sont conformes aux exigences essentielles

et aux autres stipulations pertinentes de la Directive 2014/53/EU.

A HID Global, por meio deste, declara que estes leitores de proximidade estão em conformidade com as

exigências essenciais e outras condições da diretiva 2014/53/EU.

HID Global bestätigt hiermit, dass die Leser die wesentlichen Anforderungen und anderen relevanten

Bestimmungen der Richtlinie 2014/53/EU erfüllen.

HID Global dichiara che i lettori di prossimità sono conformi ai requisiti essenziali e ad altre misure rilevanti

come previsto dalla Direttiva europea 2014/53/EU.

Download copies of the Radio Equipment Directive Declaration of Conformity (DoC) at:

http://www.hidglobal.com/certifications

Russia

Дата изготовления указана на маркировке оборудования

Представитель в Российской Федерации

Название

ООО «Дофин»

Адрес

140573, РФ, Московская обл., Озерский район, с. Бояркино

Контактное лицо

Л.Н. Голубова

Телефон

+7 495 223 6008

e-mail

[email protected]

Israel

‫.יטוחלא הלעפה ןוישרמ רוטפ חוקלה ,דבלב חוקלה לש ימצע שומישל ״קזב תלועפב״ קר‬

‫.רחא ינכט יוניש לכ וב תושעל אלו ,רישכמה לש תירוקמה הנטנאה תא ףילחהל רוסא‬

Destructive

Endurance

Stand-By

Attack Level

Level

Power Level

Level I

Level IV

Level I

‫.יטוחלא הלעפה ןוישרמ רוטפו ״ינשמ״ סיסב לע וניה רישכמב שומישה‬

E4662

Canada Radio Certification

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts

de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire

de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

CAUTION: Any changes or modifications to this device not explicitly approved by the manufacturer could

void your authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Taiwan

根據NCC低功率電波輻射性電機管理辦法規定:

第十二條

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻

率、加大功率或變更原設計之特性及功能。

第十四條

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立

即停用，並改善至無干擾時方得繼續使用。

前項合法通信，指依電信法規定作業之無線電通信。

低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

Korean KCC

항목

송신주파수

수신주파수

출력

RFID: 10m에서 47.544mv이하

Conditions

전원

전파형식

발진방식

변조방식

Singapore

Complies with

IMDA Standards

DA103548

South Africa

Brazil

Compliance Statement

Este produto está homologado pela ANATEL, de acordo com os procedimentos regulamentados pela

Resolução 242/2000, e atende aos requisitos técnicos aplicados. Para maiores informações, consulte o site

da ANATEL - www.anatel.gov.br

This product is homologated at ANATEL according to procedure regulated by Resolution 242/2000, and it

complies with the applicable technical requirements. For more information, consult ANATEL website - www.

anatel.gov.br

RF Warning Statement

Per Article 6 of Resolution 506, equipment of restricted radiation must carry the following statement in a

visible location:

Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência

prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em

caráter primário.

This equipment operates in secondary character, meaning it does not have the right of protection against

harmful interference, even against those the same character, and it cannot cause any interference to

systems operating in the primary character.

Equipment

8T2 9

ACC Control READER

PLT-04026, Rev. B.3

hidglobal.com

Part of ASSA ABLOY

For technical support, please visit: https://support.hidglobal.com

25B

규격

RFID:13.56 MHz

DC 12.0V

A1D

X-tal

RFID: ASK, NFC: GFSK

UAE

Australia and New Zealand

TRA

REGISTERED NO:

ER72356/19

DEALER NO:

E4662

DA37204/14

TA-2019/920

APPROVED

General Signaling

Equipment

ABCD12345678

CIDF18000157