Gainsborough H243 Інструкція із застосування - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція із застосування для Зовнішнє освітлення Gainsborough H243. Gainsborough H243 3 сторінки. Solar lighthouse
Друкувати сторінкуSolar Lighthouse
Please read and retain these instructions for future reference
OPERATION
FOR FIRST TIME USE:
Step 1:
Fully charge the battery before first use. Charge under direct sunlight in
the <ON> position for 2 days. The switch is located on the perimeter of the
lighthouse top (near the clear lens). See Figure 1. Your solar light will
automatically turn on once it gets dark.
CHANGING THE BATTERY
Step 1:
Remove the lighthouse top by turning in a counter clockwise direction until it
separates from the lighthouse (Figure 1).
Step 2:
Push the switch to the <OFF> position.
Step 3:
Remove the battery compartment cover
(Figure 2).
Step 4:
Carefully remove the old battery
(Figure 3).
Step 5:
Replace the battery with an equivalent new solar rechargeable battery;
ensuring the correct polarity is observed.
Step 6:
Reassemble the unit by reversing the above procedure.
TROUBLE SHOOTING TIPS
If your solar light does not come on at dusk despite following all instructions please try the following steps:
1. Make sure that the solar light is not affected by any other light source.
2. Ensure the solar light does not stand in the shade all day.
3. Check to see if the batteries are installed correctly.
4. If there is a protective film on the solar panel remove it.
Care and Maintenance Recommendations
1. Clean solar panel with a soft sponge every couple of weeks.
2. Make sure all connectors are still tight and no water getting in.
3. During the winter if you can bring it inside and give a good clean ready for next year.
BATTERIES
•
Keep batteries away from children and pets.
•
Do not mix used and new batteries.
•
Remove the batteries if left for long periods.
•
Never dispose of batteries in a fire.
Instructions for Use
H243
v001: 16/12/20
Figure 1
Figure 2
Figure 3