Gainsborough K241 Інструкція з монтажу та інструкція з використання
Переглянути онлайн або завантажити pdf Інструкція з монтажу та інструкція з використання для Зовнішнє освітлення Gainsborough K241. Gainsborough K241 2 сторінки. Set 6 cut out 2 in 1 solar lights
Друкувати сторінкуSet 6 Cut Out 2 in 1 Solar Lights
K241
v001: 09/08/21
Please read and retain these instructions for future reference
1*2/3AAA100 Ni-Mh – Rechargeable
(included)
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Before using first time
Allow lamp to charge for at least 8 hours in full sunlight with the ON/OFF switch in the ON position. The
ON/OFF switch is located under the solar panel. Once the batteries are fully charged, set the ON/OFF switch
to ON. If the lamp does not turn on after dark refer to Maintenance section.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically
To easily insert stakes into the ground, it is recommended to wet the ground first. To avoid damaging garden
stakes when inserting into the ground, select a spot in soft, rock-free soil. Insert the base of the stake first
then gently insert the rest of the stake into the base. DO NOT push directly against the solar cell or the
ornament housing containing the actual LED light.
ALWAYS POSITION IN DIRECT SUNLIGHT
Dimensions
37.5* 6.9* 6.9cm (with hook: 43cm)
•
2 IN 1 FUNCTION – HANG OR STAKE
•
CREATES A LOVELY REFLECTIVE LIGHT
PATTERN
•
SIZE OF LANTERN – 10.3 X 6.9 X 6.9 CM
•
CHARGING TIME – 8 HOURS
•
WARM WHITE LEDS (not replaceable)
•
AMORPHOUS SILICON SOLAR PANEL
•
OFFERS HIGHER EFFICIENCY, CAN WITHSTAND
HIGHER TEMPERATURES WITHOUT OUTPUT
BEING AFFECTED, PERFORMS BETTER IN LOW
LIGHT CONDITIONS
•
LIGHTING MODE – ON / OFF / LIGHT SENSOR
•
WATERPROOF – IP44 RATED