Hiddn LapTop1+ Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Зберігання Hiddn LapTop1+. Hiddn LapTop1+ 4 сторінки.
Друкувати сторінку1. Introduction
After being installed, initialized and the operating system loaded (refer to LapTop1+ Installation
Manual) the computer is ready for use. Key Tokens (User, Backup and Zeroize) can either be
purchased with the [hiddn]® LapTop1+, or if you or your organization have a [hiddn]® Key
Management System (KMS) smart cards can be programmed by the KMS Administrator.
In this User Guide the following topics are described:
•
Normal operation
•
Changing PIN/password
•
Displaying status information
•
Using the Backup Key token
•
Zeroizing the unit
2. Normal Operation
Power on your computer.
1.
Insert the User Key Token when the message "Waiting for Key Token. Please insert..." appears
2.
on the screen.
Insert your User Key Token. If this is the first time you use the User Key Token, the message
3.
"New User Key Token Detected. Press any key to continue..." will appear.
Enter PIN/password and confirm by pressing Enter
4.
The computer will establish a secure communication channel between the Key Token and the
5.
[hiddn]® LapTop1+ over the SATA interface. When the data encryption keys are transferred to
the [hiddn]® LapTop1+ the computer will restart and boot from the operating system on the
encrypted drive.
Remove the User Key Token and assume normal operation. (ref note 3)
6.
If you by accident type the PIN/password incorrect too many times (typically the limit is 3 times) the
Key Token is locked. When this happens, the computer asks for a PUK. This is a 16 digit code used for
unlocking the Key Token. The PUK is either displayed for you when first powering on the unit, or, if
you have a [hiddn]® KMS Administrator at your service, you might contact him/her to get the PUK. If
you enter the PUK incorrectly too many times (typically the limit is 10 times) all keys will be wiped
from the smart card. In such cases you need a spare User Key Token or Backup Key Token.
When contacting the KMS Administrator to request a PUK, the Key Token serial number (ref chapter
4) can be used to identify the card in the KMS database.
NOTE 1: "Sleep Mode" is not supported and should be disabled by your System Administrator. Data
will be lost if "Sleep Mode" is activated, use "Hibernation" instead.
NOTE 2: The keys loaded into your [hiddn]® LapTop1+ will expire and be erased when you power off
the computer. This also applies for "Hibernation Mode". If, by any means, you computer should
require a reboot, this can be done without loading keys since the [hiddn]® LapTop1+ will normally not
lose power during this operation.
NOTE 3: Always store the User Key Token in a safe place and away from the computer once removed
from the smart card reader.
AS
Hiddn Security
http://www.hiddn.no
//