Hideaway Soft Close Series Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Аксесуари для прання Hideaway Soft Close Series. Hideaway Soft Close Series 4 сторінки. 60l base mounted laundry hamper
Також для Hideaway Soft Close Series: Інструкція з монтажу (2 сторінок)

Друкувати сторінку

Drilling Template 1 pictured below.

NOTE: Remove template from cabinet

when pre-drilling is complete.

Fully extend the Base Unit to ensure

the Base Unit opens and closes without

coming in to contact with cabinet sides.

Then fully extend again and secure the

remaining mounting points of both base

sides with 16mm screws provided.

Position the Door Support Bracket over

mounting holes and secure with 12mm

screws provided.

NOTE:

Alternative mounting holes are

provided on the outside edge of the

door mounting bracket, for door panels

with centre inserts (profile doors). The

alternate mounting points do not need to

be used if the inner mounting holes are

used and vice versa.

Install the base unit over the pre-drilled

mounting holes. Secure with 1x 16mm

screw at the front of each base side.

Step 3 - Door attachments

Use the

Door Support Bracket and

Handle Support Drilling Template 2

(pictured below) to mark mounting

positions on the door fascia.

Pre-drilling instructions are shown on the

drilling template.

Position the Handle Support Bracket

over the pre-drilled mounting holes and

secure with the 12mm screws provided.

Image below: Door panel with door

mounting bracket and handle support

bracket attached.

Secure with 1x 16mm screw at the

back of each base side.

Use the Drilling Template 2 provided

(pictured below) to mark mounting positions

Door Support Bracket and Handle

for

Support

Bracket. Pre-drilling instructions

are shown on the Drilling Template 2.

Please follow instructions and move on to

Step 3b

NOTE:

Remove template when completed.

Step 4 - Reattach door bracket

(now with door fascia attached)

Set the CAM adjustment in the

horizontal position, as indicated by the

arrow on the CAM.

Align and reattach the door mounting

bracket (now fixed to the door fascia) to

the base unit as pictured.