GainSpan GS1011MIP-EVB Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Материнська плата GainSpan GS1011MIP-EVB. GainSpan GS1011MIP-EVB 12 сторінок. Serial to wi-fi evaluation kit

Друкувати сторінку

-F

ERIAL TO

Below are the steps required to run the serial to Wi-Fi application.

1. Once the software installation is completed, power the Wi-Fi Access Point (AP). The access point

have been pre-configured with the following parameters:

a. SSID = "GainSpanDemo

b. Channel = 6

c. DHCP = Enabled

d. Security = Open

e. IP Address = 192.168.3.1

Note: If user wants to use a different AP than the one provided with the kit, user can use any standard

Wi-Fi (802.11 b/g/n) AP, they should just ensure that the AP settings match the parameters above.

2. Plug the serial cable provided directly into a serial communications port of the PC if one is

available, or into a USB-to-serial converter. Since USB converters can enumerate to any one of a

number of COM ports, it is necessary to find the COM port of the serial port or USB converter being

used to communicate with the board. Open the Device Manager (Figure 1): Start → Settings →

Control Panel → System → Hardware → Device Manager. The USB Serial Port is listed under

as shown below

(COM & LPT),

Figure 1: System Properties pane with Device Manager Button

RELIMINARY

ETUP AND

TART

AGE

Serial to Wi-Fi Start Up Guide

NSTRUCTIONS

Ports

ONFIDENTIAL