Dynamic DX2-PMA90LG Доповнення до посібника з встановлення - Сторінка 14
Переглянути онлайн або завантажити pdf Доповнення до посібника з встановлення для Блок управління Dynamic DX2-PMA90LG. Dynamic DX2-PMA90LG 20 сторінок. The ultimate powerchair control solution
Друкувати сторінку
4.2 Parameter descriptions
4.2.1 Gyro Configuration
4.2.1.1 Gyro Profile Select
Parameter
Gyro Profile Select
This parameter is only used in the DX2-PMA90LG Power Module in combination with a
DX2-GYRO stabilisation module. Gyro stabilisation will only occur when a DX2-GYRO
module is connected to the Power Module.
The Power Module has 4 Gyro Profiles (G1 - G4) that can be used to adapt the Gyro
behaviour to different circumstances, for example smooth or rough terrain.
The Gyro Profile Select parameter assigns a specific Gyro Profile to a Drive Profile, to
provide Gyro stabilised drive performance in that Drive Profile. Each Drive Profile can
have its own Gyro Profile.
To disable Gyro use in a Drive Profile (for example, a Drive Profile for use on buses or
trains), set Gyro Profile Select for that Drive Profile to 'Gyro Off'. In this case the
standard drive parameters are used and no Gyro stabilisation occurs.
: Issue 2.03 - May 2012
GBK65248
14
Possible Values Default
Gyro Off
Profile G1
Profile G2
Profile G3
Profile G4
Notes:
1. It is not possible to switch between a non-Gyro Drive Profile and a Gyro
Drive Profile while driving. If a switch is made during driving, the chair will
stop and an OONAPU condition will occur. The joystick must be released
to the centre before the chair will drive again.
2.
If the Gyro module is not connected and a Gyro-stabilised Drive Profile is
selected, the Gyro Profile limits the maximum speed of the chair to the
value of the Gyro Fault Speed Limit parameter (4.2.2.6). This makes sure
that the chair remains stable in the absence of Gyro stabilisation.
Warning:
Gyro Control cannot be used inside moving vehicles such as buses or trains.
If a chair with Gyro Control is used on a bus or a train, make sure that either
the DX System is turned off or that a non-Gyro stabilised drive profile is
selected, before the vehicle starts moving. To achieve this, the user must be
able to select a Drive Profile where the Gyro Profile is set to 'Gyro Off'.
The Gyro module is not operational as long as the joystick is in the neutral
position.
HHP
Lite
Gyro Off
-
Std
Adv