Dynamic DX2-PMA90LG Доповнення до посібника з встановлення - Сторінка 19
Переглянути онлайн або завантажити pdf Доповнення до посібника з встановлення для Блок управління Dynamic DX2-PMA90LG. Dynamic DX2-PMA90LG 20 сторінок. The ultimate powerchair control solution
Друкувати сторінку
6 Appendices
The DX2-PMA90LG is a variant of the DX2-PMA family. Please see the appendices of
the DX2-PMA installation manual for all DX2-PMA information, which also applies to
the DX2-PMA90LG.
In the appendices below, only DX2-PMA90LG-specific information is shown.
6.1 Intended Use and Regulatory Statement
Intended Use
The DX2-PMA90LG variant of the DX2 Power Module family is intended to allow the
DX2-Gyro module interact with the DX2 System, to improve directional control of
wheelchairs - particularly front wheel drive chairs - under both normal driving and
adverse traction conditions.
For a description of the DX System and the corresponding device classification,
please refer to the DX2-PMA installation manual.
6.2 Safety and Misuse Warnings
The DX2 Power Module is part of the DX System and therefore all safety and misuse
warnings that appear in the DX System Manual apply to the DX2 Power Module as
well. See DSM section 10.4.
Additional warnings to be included in the User Manual
The following warnings must be passed on to the operator of the vehicle before use
of the product.
Gyro Control cannot be used inside moving vehicles such as buses or trains. If you
use a chair with Gyro Control on a bus or a train, make sure that either the chair is
turned off or that a non-Gyro stabilised drive profile is selected, before the vehicle
starts moving.
: Issue 2.03 - May 2012
GBK65148
19