Gait up PhysiGait Lab Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади Gait up PhysiGait Lab. Gait up PhysiGait Lab 18 сторінок. User manual and outcome parameters

Друкувати сторінку

When using the watch for the first time with the sensor pair, check that

the correct serial numbers are entered in the settings. For this, press the

gearwheel button at the bottom of the screen and control that the two set

numbers correspond to the serial numbers written on the back of the

sensors. To change the values, click on the number field and enter the

correct serial numbers for the left and right foot sensors, then click

"Done".

Briefly push the button on the sensors (1sec) to activate their Bluetooth (do not start a

recording). The app shows "Connecting" then "Connected" for both sensors. Install the

sensors on the feet of the subject as suggested above and get ready for the recording.

To start the sensor recording, press the lower right button of the smartwatch once. The

status of the sensors will change to "Ready" and the recording has started.

When pressing the lower button of the watch again, the app stopwatch starts to run.

To stop the recording, press the lower button again, the stopwatch and sensors stop

recording.

3.6

Plug the Physilog

For both recording options, data saved on the SD card inside the Physilog® can be

accessed using USB data transfer. Therefore, plug the micro-USB cable end to the

Physilog® and the USB connector to a computer. The Physilog®5 connects to the computer

almost instantaneously and files can be accessed like from a USB key.

3.7

Transfer

One file for each measurement is created and files are stored in folders depending on

creation date (YY_MM_DD for firmware v1.2.2 upwards, DD_MM_YY for firmware v1.1.0).

The file name is composed of a file number (increasing from 1 to 999), the body location (as

defined in the configuration, f.ex. 'LF' for left foot) and the sensor serial number (written on

the back of the sensor).

measurement with two sensors generates two files (one per sensor, i.e. one per foot).

Retrieve the corresponding files from the memory of each sensor and store the file pairs

from the gait test in the same folder on the computer to be analysed together. From here

you can also rename folders and files or delete the files from Physilog®'s memory.

PhysiGait Lab user manual v1.3.1 Date: 29.04.2019

to a computer

Copy-paste the files to your computer for analysis, a gait

EPFL Innovation Park, Bat C. CH-1015 Lausanne

Gait Up SA

www.gaitup.com

TVA CHE-145.136.760