ADEMCO 5808C Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Димова сигналізація ADEMCO 5808C. ADEMCO 5808C 4 сторінки. Wireless photoelectric smoke detector

An ADEMCO Group Company

5808/5808C

Ordering Information

Part No.

Description

5808

Smoke/Heat

Detector

w/Sounder

5808C

Smoke/Heat

Detector

Maintenance

Note: Before removing the detector, notify the proper authorities that the smoke detector

system is undergoing maintenance and will be out of service. Disable the zone or system

undergoing maintenance to prevent unwanted alarms.

1.. Remove the detector cover by placing a small bladed screwdriver in the cover removal

slot and twisting it slightly until the cover can be turned counterclockwise for removal.

2. Remove the screen by pulling it straight out. Vacuum the screen thoroughly.

3. Clean the black vaned chamber piece by vacuuming or blowing out dust and particles.

4. To reinstall the screen, rotate the screen on the housing until it drops into the alignment

slots. Carefully push the screen onto the base, making sure it fits tightly to the chamber.

Replacement screens are available (order part number RS23).

5. Replace the cover by rotating it clockwise until it locks into place.

6. Reinstall the detector into the system, enable the system operation, and notify the proper

authorities that the system is back on line.

To keep your equipment in excellent working order, ongoing maintenance is required per the

manufacturer's recommendations and UL and NFPA standards. At a minimum, the

requirements of Chapter 7 of NFPA 72, the National Fire Alarm Code, shall be followed. A

preventative maintenance agreement should be arranged through the local manufacturer's

representative. Though smoke detectors are designed for long life, they may fail at any time.

Any smoke detector, fire alarm equipment, or any component of that system which fails

shall be repaired or replaced as soon as possible.

ADEMCO is an ISO9001 Registered Company

L/5808C/D 1/99