Gait up Physilog 5 Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Аналітичні інструменти Gait up Physilog 5. Gait up Physilog 5 17 сторінок.
Також для Gait up Physilog 5: Посібник користувача (12 сторінок), Посібник користувача (17 сторінок)

Друкувати сторінку

Gait Up SA

EPFL Innovation Park, Bat C. CH-1015 Lausanne

www.gaitup.com

TVA CHE-145.136.760

Firmware before v1.1.0:

The Physilog®5 sensors synchronize automatically at start when they are correctly configured. Slave

sensors contain a file named "slave.txt", the Master sensor doesn't have such a file. You can create

and delete the "slave.txt" file as you need for your sensor network configuration. A sensor network

can contain as many slave sensors as wished, but there must be a single Master sensor.

Multiple sensor networks can be created by selecting a different radio channel, therefore create a

file called "radio.txt" and write a number between 2 and 80 inside the file (which sets the radio

channel) and copy-paste it on all Physilog® (also the Master) that are part of a network. Each

network should have a different radio channel in order to exclude cross-talk and one and only one

Master per network must be defined.

To perform a measurement with synchronized Physilog®5 follow the steps below:

1) Start the sensors with the main button (like for standalone measurement above). One of the

sensors (Master) will start to blink green, the others (Slaves) shine green and don't record until they

receive the synchronization signal from the Master sensor.

2) Once the sensors are synchronized, they blink green synchronously with the Master sensor and

record.

3) To stop the measurement, press the main button of the Slave sensors. They shine green until they

have received the final synchronization information from the Master. The Master must be turned

off as last, after all the Slave sensors have turned off the green LED.

To start a Slave sensor without receiving the signal from the Master, shortly press the main button

when it is shining green, the sensor will start the measurement without being synchronized to other

sensors. To stop slave sensors without waiting for Master synchronization, shortly press the main

button again when the LED is shining green after turning off the recording.

3.3. Start measurement from Android application

The GaitUp companion Android application allows to start Physilog®5. Two modes are available in

the application, for details refer to the user manual of the Android application. There is no need to

pair your Physilog® with the tablet prior to Bluetooth communication, just select the Physilog® from

the list in the app.

Troubleshoot: If a sensor is not detected by the tablet, shortly press the main button of the sensor

to enter detection mode. If the sensor can still not be connected, check that it has enough battery

and is not connected to another mobile device and if necessary ultimately do a reset of the sensor

as explained in section 5.7 Troubleshoot.

Physilog5 user manual v1.2.6 Date: 19.06.2018