Hidro-Water NELVA Посібник - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник для Системи фільтрації води Hidro-Water NELVA. Hidro-Water NELVA 17 сторінок.

e. Once you have replaced one of the cartridges/membrane – with the faucet

(Figure 2) open – open the brass ball valve (Figure 5) at the water supply. Let

all of the air out from inside the ultrafiltration system. Once a continual water

flow comes out of the faucet, let it run for 30 seconds and then close the fau-

cet. If in the beginning, the water runs black, don't worry, this is normal, it's

caused by the residue that the granulated carbon filter lets off. Drain this wa-

ter. The water will run clear not long after this. Check for leaks, if there are

any, close the valves and fix them.

Precaution 1: If there is any water leak in any area of the tube connections,

remove it and cut off 0.5cm. Then reconnect it. If the leak s

produced on any thread, unscrew the piece, apply more Teflon

and screw it back on.

6.2. PROCEDURE FOR REPLACING THE WATERSTOP ANTILEAK ABSOR-

BENT MATERIAL

In the case of having to change the WATER STOP Antileak absorbent

material; you must do as follows:

a. Raise the arm on the WATER STOP Antileak system, to cut off the water

supply (if there is a leak the arm will already be raised).

b. Throw away the current absorbent material.

c. Replace it with a new absorbent material.

d. Lower the arm on the WATER STOP Antileak system and it's ready for use.