Dynamic Engineering PCI2PMC Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для PCI карта Dynamic Engineering PCI2PMC. Dynamic Engineering PCI2PMC 15 сторінок. Pci single slot pmc compatible carrier use your pmc in a pc
Друкувати сторінкуApplications Guide
Interfacing
Some general interfacing guidelines are presented below. Do not hesitate to contact the
factory if you need more assistance.
Installation
The PMC is mounted to the PCI2PMC prior to installation within the chassis. For best
results: with the PCI bracket installed, install the PMC at an angle so that the PMC front
panel bezel penetrates the PCI bracket then rotate down to mate with the PMC [JnX -
PnX] connectors.
If the PCI bracket is not installed, plug in the PMC and then attach the PCI bracket. Use
the mounting screws that come with the PMC to secure to the PCI2PMC.
There are four mounting locations. Two into the PMC mounting bezel and two for the
standoffs near the PMC bus connectors.
Start-up
Make sure that the "system" can see your hardware before trying to access it. Many
BIOS will display the PCI devices found at boot up on a "splash screen" with the
VendorID and CardId for the PMC installed and an interrupt level.
Watch the system grounds. All electrically connected equipment should have a fail-
safe common ground that is large enough to handle all current loads without affecting
noise immunity. Power supplies and power consuming loads should all have their own
ground wires back to a common point.
Power all system power supplies from one switch. Connecting external voltage to
the PCI2PMC when it is not powered can damage it, as well as the rest of the host
system. This problem may be avoided by turning all power supplies on and off at the
same time. This applies more to the PMC installed into the PCI2PMC than the
PCI2PMC itself, and it is smart system design when it can be achieved.
Embedded Solutions
Page 1 0