Dynamic Engineering PMC2PCI Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Конвертер мультимедіа Dynamic Engineering PMC2PCI. Dynamic Engineering PMC2PCI 9 сторінок. Pmc to pci converter
Друкувати сторінкуPCI card installed into the PMC2PCI than the PMC2PCI itself, and it is
smart system design when it can be achieved.
Construction and Reliability
The PMC2PCI is constructed out of 0.062 inch thick FR4 material. The
components on the PMC2PCI are tied into the internal power planes to
spead the dissipated heat out over a larger area. This is an effective
cooling technique in the situation where a large portion of the board has
little or no power dissipation. In addition the power dissipation of the SMT
regulator and the zero delay buffer are minimal.
Surface mount and through hole components are used.
The PMC Module connectors are keyed and shrouded with Gold plated pins
on both plugs and receptacles. They are rated at 1 Amp per pin, 100
insertion cycles minimum. These connectors make consistent, correct
insertion easy and reliable.
The PMC Module is secured against the carrier with the PMC connectors.
It is recommended, for enhanced security against vibration and to help with
the PCI card installation, that the PMC mounting screws are installed. The
PMC2PCI is shipped with the bezel mounted and the stand-offs installed.
Screws are supplied to secure to the host card.
Dynamic Engineering has replacement screws, standoffs, blank bezels and
other PMC hardware available at a reasonable cost.
Thermal Considerations
If the PCI installed has a high heat dissipation then forced air cooling is
recommended.
Page
6
Electronics Design • Manufacturing Services