Celestron 47003 Інструкція з експлуатації

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Метеостанція Celestron 47003. Celestron 47003 15 сторінок. Personal weather station with wireless remote sensor

Друкувати сторінку

Personal Weather Station with

Wireless Remote Sensor

Model # 47003

Thank you for purchasing this Celestron personal

weather station. Please read the instructions prior to

using it and we hope you will have many years of

pleasure with it.

Insert the base to the bottom of the Receiver by

pushing it in until it clicks. The correct position is

shown in the image to the right

Set Up Power for the Receiver

For optimum performance, please place the Receiver away from metal and

other sources of interference such as mobile phones, TVs, computers,

appliances, etc. If the Receiver stops showing the display or dims, replace

the batteries.

Set Up the Power & Make Settings for the Wireless Remote Sensor

Remove the screw (center area of center image) from the rear door of the sensor with a small

screwdriver. Insert two AAA batteries (user supplied) as indicated in the sensor (see right image).

Set the switch to "1" (for Channel 1) - or if no switch is seen then nothing to do, push/toggle the

button so readings will be shown in "C" (Centigrade) or "F" (Fahrenheit). Then push the button

"TX" and hold it a couple of seconds to transmit the RF signal from the Sensor to the Receiver. The

Sensor itself will display the outside temperature (see left image). Replace the rear door of the sensor

by installing the screw to hold it in place.

The Sensor can be mounted up to 100 feet (30 meters) in an open area from the Receiver to

communicate with it. The Sensor has a place on the rear of the unit to mount/hang it securely

(hanger part on left of center image) to any surface that is secure or it can stand by itself (if in an area

without wind, etc.).

Open the battery compartment door on the rear of the Receiver.

Then insert two AAA batteries (user supplied) with polarity as

indicated in the battery compartment. After installation, put the

battery compartment door back on.