Celestron 47011 Інструкція з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Метеостанція Celestron 47011. Celestron 47011 15 сторінок. Personal weather station with wireless remote sensor
Друкувати сторінку
Weather Forecast & Barometric Pressure Bar Chart – the weather station has a built-in
barometer to measure atmospheric pressure and forecasts the weather with icons for
Sunny/Partly Cloudy/Cloudy/Rainy/Stormy. In setup you choose the current weather icon. The
unit predicts the weather conditions of the next 12 to 24 hours based on the atmospheric pressure
and is about 70% correct. The company accepts no liability for any incorrect weather forecast. A
weather trend indicator bar is shown below the time display.
Backlight of Display – the brightness of the display can be set for Off/Low/High/Auto by
moving the switch on the rear of the Receiver. It is suggested to use the "Auto" mode which will
adjust the brightness automatically for optimum display by using a built-in sensor.
Alarm Setting – Press and hold the "ALARM" button on the rear of the Receiver to enter the
setting mode. Enter the desired hour and minute values by pressing the up and down arrow
buttons and pressing "ALARM" to set each. Press "ALARM" to show the alarm time and the
"AL." icon will be displayed briefly and then press the "ALARM" again to have a red colored
bell appear meaning that the alarm is enabled. To turn the alarm off (disable) press "ALARM"
again and the bell icon will disappear.
Snooze – when the alarm goes off, press "Channel/Snooze" button to go into snooze mode and
the bell icon will flash. The alarm will go off again after 5 minutes and continue doing this if
you push the "Channel/Snooze" button. To stop the alarm for 24 hours, press the "ALARM"
button.
Specifications:
Indoor Temperature Range = 0º to +50º C ( + 32º to + 122º F)
Remote Sensor Temperature Range = -20º to + 60º C ( -4º to + 140º F)
Forecast Accuracy = about 70%
Display = VFD (Vacuum Fluorescent Display)
Clock = digital quartz
Power = 7.5 Volt AC Adapter & backup batteries (two LR44) for Receiver and 2AAA batteries
(user supplied) for Wireless Remote Sensor
Transmission = RF434 MHz
Dimensions = Receiver – 2.8" x 2.5" x 8.4" (71mmx64mmx213mm) Sensor - 2.5" x 1.0" x 3.6"
(64mmx25mmx91mm)
Weight = Receiver - 10oz (284g) Sensor - 3oz (85g)
2835 Columbia St.
Torrance, California 90503 U.S.A.
www.celestron.com
Printed in China 0110
RoHS