AutoMotionShade 4300P Короткий довідник - Сторінка 2

Переглянути онлайн або завантажити pdf Короткий довідник для Двигун AutoMotionShade 4300P. AutoMotionShade 4300P 2 сторінки.

4. Press and hold again either the left or the right programming button (3 or 4); the shade moves up until it reaches

your desired top limit; if it goes too fast/slow, you can release and press the same button (3 or 4) again to switch

to a slower/faster speed. Once you reach the top limit, release button (3 or 4). Now press and hold the 'Save'

button (5) until the right LED light (2) comes ON, then release it.

5. Now press and hold again the left or right programming button (3 or 4) and move the shade down until you reach

the desired bottom position, then press and hold the 'Save' button (5) until the right LED light (2) comes on. The

desired top and bottom shade positions have now been set.

6. Release the Dash-Switch that you have been holding down all along.

7. Disconnect the programmer from the white motor pig tail wire by holding the connectors and not the wires (see

Illustration above (A).

8. Finally, check the end positions by operating the shade up and down by means of the dash switch.

Important Note:

The programmer needs to be disconnected after the programming process is finished. Never leave the programmer

connected to the motor!

407: R-2: 06/20

Effective Date: Jun 2020