Automotive Tazer DT Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Автомобільні аксесуари Automotive Tazer DT. Automotive Tazer DT 9 сторінок. Programmer/light show

Submenu Other:

Set AUX:

This setting is to configure the vehicle for AUX button package.

Set Blind Spot:

This setting is to configure the vehicle for blind spot detection package.

Set Belt ding:

This setting is to delete the seat belt reminder chime. The reminder icon will remain on

the dash. Always wear your seatbelt!

Set Splash: With this setting you can choose the cluster splash screen: There are many choices

but not all will work, and some may set an error.

Set Panic: With this setting you can choose whether the PANIC button on the keyfobs will be

enabled or not.

Firmware Version Display:

Full Reboot:

If selected, will reset vehicle modules and the radio twice. This takes 2.5 minutes to

complete,

and should be performed after any Vehicle Settings that affect the radio are changed

radio will reboot twice in this time, the dash will reset, and when it's finished, the

the dash will turn

on. Once complete, shut off the vehicle, open and close the driver door and wait for a

minute to be sure the dash turns off.

This section explains how to use the Tazer JL's live functions – these are

activated with the same button presses as the Settings Menu, but while the

engine is RUNNING.

Light Show:

This is one method of activating the light shows. Selecting this will activate the first show,

unless ZPU was used to change the startup show. There are 9 light shows – you can toggle through all 9,

then back to OFF.

Set In-Motion Nav:

system while vehicle is moving. This is for the PASSENGER to use. It may be illegal for the driver to use

the navigation system to enter information while the vehicle is in motion. On RA3/RA4 radios, it will

also allow the text feature and switching drive mode settings while in motion. It is recommended to

leave this setting OFF, enabling it only when you need to use it. This will automatically be disabled if

TurnCAM is enabled.

Shows the current Tazer JL firmware revision.

Live Menu Settings

These features will only work if the Tazer JL remains

If set ON, this adds the ability for address info to be entered into the navigation

plugged in.

– the

red security dot on