Hidrotermal Hidro-ST80 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Залізо Hidrotermal Hidro-ST80. Hidrotermal Hidro-ST80 12 сторінок.
Друкувати сторінку
2. Operational Setting
2-1. Controller installation
A. The controller should be installed outside of the steam room with convenience access for operations. Please
install it as near as possible to the room's door. The recommended height is 1.5meter above from the ground.
B. Dig a hole with diameter 30mm before installation, tear off the adhesive's paper behind the controller, fix the
controller and then seal the sides with sealant or silicone.
2-2. Controller Operation-Type 4
A. On / off button: start or stop steam generator. This
button is used to turn on or shut off the power.
1) the Timer display window. It shows the remaining
time, the machine will turn off when the display
reaches "0".
2) Temperature display shows the steam room
inside temperature.
B.Light control button: To turn on or turn off the
cabin's light.
C.Setup button: Set the temperature and time.
1) Press "SET" gently and the timer display show
two figures of time, press "UP" and "Down" to set
your desired period, the machine will turn off when
the counter precipitation "0". The Time setting range
is 1 -60 minutes. Machine default time is 45 minutes.
2) Press "SET"key again, the temperature display
show two figures of temperature, press "UP" and
"Down" to set your desired temperature. The
temperature setting range is 35-55 ℃, Machine
default temperature is 40 ℃.
3) Press "SET" key once more to save the above
setting. And the setting state will return after 15s
without operation.
D. The the temperature is inside the steam room is higher than the target, the machine will stop generating steam.
The constant temperature indicator light is on and the heat indicator light is off. When the temperature lower the
desired temperature, the machine will continue to heat water untill arrive the temperature reach target again. The
heat indicator light is on and the constant temperature indicator light is off. The steam generator will automatic
control the steam room temperature within the range of +/- 2degree.
Constant
temperature
indicator light
Time display
Up button
Setting button
Sauna room light control
Controller- Type
Heat indicator light
Temperature
display
Down button
On/Off