Dynamic Power TriFuel Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Інвертор Dynamic Power TriFuel. Dynamic Power TriFuel 17 сторінок. Triple fuel generator. trifuel-red
Друкувати сторінкуMAINTENANCE & REPAIR
The Importance of maintenance
Good maintenance is essential for safe, economical, and trouble-tree operation. It will also help reduce air pollution.
WARNING:
Improper maintenance, or failure to correct a problem before operation, can cause malfunction in with you can be
seriously hurt or killed.
Always follow the inspection and maintenance recommendations and schedules in this owner's manual.
To help you properly care for your generator, the following pages include a maintenance schedule, routine inspection
procedures, and simple maintenance procedures using basic hand tools. Other service tasks that are more difficult, or
require special tools would best handled by professionals, normally preformed by generators or other qualified mechanic.
The maintenance schedule applies to normal operating conditions. If you operate your generator under sever conditions,
such as sustained high-load or high-temperature operation, or use it in unusually wet or dusty conditions, consult your
servicing needs and use.
Maintenance Safety
•
Make sure the engine is off before you begin any maintenance or repairs.
•
Let the generator and exhaust system cool before touching.
•
Read the instructions before you begin, and make sure you have the tools and skills required.
•
To reduce the possibility of fire or explosion, be careful when working around gasoline. Use only a nonflammable
solvent, not gasoline, to clean parts. Keep cigarettes, sparks, and flames away from all fuel-related parts.
Emission Control System Information
Soured of Emissions
The combustion process produces carbon monoxide, oxides of nitrogen, and hydrocarbons. Control of hydrocarbons and
oxides of nitrogen is very important because, under certain conditions, they react to form photochemical smog when
subjected to sunlight, Carbon monoxide does not react in the same way, but it is toxic.
Engine utilizes lean carburetor setting and other systems to reduce the emissions of carbon monoxide, oxides of nitrogen,
and hydrocarbons.
Tampering and Altering
Tampering with or altering the emission control system may increase emissions beyond the legal limit. Among those acts
that constitute tampering are:
•
Removal or alteration of any part of the intake, fuel, or exhaust systems.
•
Altering or defeating the governor linkage or speed-adjusting mechanism to cause the engine to operate outside
its design parameters.
Problems That May Affect Emissions
If you are aware of any of the following symptoms, have your engine inspected and repaired by your servicing dealer.
•
Hard starting or stalling after starting.
•
Rough idle.
•
Misfiring or backfiring under load.
•
Afterburning (backfiring).
•
Black exhausts smoke or high fuel consumption.
Replacement Parts
The emission control systems on your generators were designed, built, and certified to conform to EPA or (and) California
emission regulations. We recommend the use of generators parts whenever you have maintenance done. These original-
design replacement parts are manufactured to the same standards as the original parts, so you can be confident of their
performance.
Using replacement parts that are not original design and quality may impair the effectiveness of your emission control
system.
A manufacturer of an aftermarket part assumes the responsibility that the part will not adversely affect emission
performance. The manufacturer or rebuild of the part must certify that use of the part will not result in a failure of the
engine to comply with emission regulations.
6