Aire WELKIN Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Вентилятор Aire WELKIN. Aire WELKIN 17 сторінок.

HANGING THE FAN-STANDARD CEILING MOUNTING

WARNING: All of the parts, hardware and components such as the hanger bracket and hanger ball have been

provided for your safety and the proper installation of your new ceiling fan. The use of other parts, hardware or

components not supplied by Aire with the fan will void the Aire Warranty.

REMEMBER to turn off the power. Follow the steps below to hang your fan properly:

Step 1. Secure the Hanger Bracket to the ceiling outlet box using the screws provided with your outlet box in

conjunction. (Fig. 6)

Step 2. Loosen the two Set Screws and remove the Hitch Pin and Lock Pin from the coupling located on the top of the

Motor Assembly. (Fig. 7)

Step 3. Remove the Hanger Ball from the Downrod Assembly by loosening the Set Screw and removing the Cross Pin.

(Fig. 8)

Step 4. Carefully feed fan wires up through the downrod. (Fig. 9) Thread Downrod into the Coupling until the holes are

lined up and secure with the Lock Pin and Hitch Pin previously removed, tighten Set Screws. (Fig. 10)

Step 5. Slip coupling cover, canopy cover and canopy onto downrod. (Fig. 10) Carefully reinstall hanger ball onto rod being

sure that cross pin is in correct position, set screws are tighten and wires are not twisted.

Step 6. Lift the Motor Assembly and place the Hanger Ball into the Hanger Bracket. Rotate the Motor Assembly as needed

OUTLET BOX

HANGER BRACKET

FIG. 6

COUPLING

COVER

LOCK

FIG. 10

SET SCREWS

HITCH

LOCK

FIG. 7

HANGER

BALL

DOWNROD

CANOPY

HITCH PIN

SCREWS

CROSS PIN

HANGER

BALL

SET SCREW

DOWNROD

FIG. 8

REGISTRATION

SLOT

FIG. 11

FIG. 9