Dynamic Sensor Systems AutoSensBIKE Встановлення - Сторінка 2

Переглянути онлайн або завантажити pdf Встановлення для Аксесуари для мотоциклів Dynamic Sensor Systems AutoSensBIKE. Dynamic Sensor Systems AutoSensBIKE 2 сторінки.

Друкувати сторінку

9. Activ

Activ

Activation of your Device

Activ

ation of your Device – After an active SIM card has been inserted and battery charged and

ation of your Device

installed, the device needs to be activated to communicate with your Android smart phone. Ensure

your AutoSens App has been loaded onto your phone (see previous item). Activation is via an SMS

sent to your device. The SMS is literal and consists of the digits inside

[admin123456_61412345678] Note the _ between the two 6s is a space.

the international version of your Android phone number. So the example above assumes your phone

number is 0412345678. So as another example - for an Android phone number 0409654321 the SMS

sent to your phone is: [admin123456 61409654321] – note space

the word admin and number 123456.

10. Setting up your App

Setting up your App – open your AutoSens App. With 'Bike ID 1' selected go to 'EDIT Bike DATA' in

Setting up your App

blue at the bottom of the home screen. Select this to set up your device details. Click the box under

'ENTER Bike ID' and enter your device name 'Harley' click 'ENTER Bike ID. Click the box under 'ENTER

Bike SMS Number' and enter the 61 version of the device SIM card number – click 'ENTER Bike SMS

Number' to enter this number. Go back to the home screen. Your bike name and its device SIM card

number should be visible (name in Blue and number under 'data' in yellow). To enter data for other

bikes, on the home screen select a new bike ' Bike ID 2' (in blue) and proceed to 'EDIT BIKE DATA' as

above for the second and subsequent bikes.

11. Check if you have a WiFi connection – if not you need to activate your service provider Data

connection on your Android phone – this enables Google maps to display the location of your Bike.

Your system is now ready to test.

12. Testing device

Testing device – Place your AutoSensBIKE device on your motor bike with the bike in an open space

Testing device

with clear view of the sky. Leave it there for about 3-4 minutes. Open your AutoSens App and press

'FIND BIKE' and hold for about 3 seconds. A map should appear showing the location of your bike. If

you receive a message saying 'no GPS data' your device is not receiving adequate GPS signal. Wait a

minute and try 'FIND BIKE' again.

13. Device placement

Device placement

Device placement – When the device has power from your bike, place it in a convenient location with

clear access to GPS satellites (plastic is 'clear' to GPS signals – so under plastic is OK). The device should

be 'attached' to a solid part of the bike in a water proof area. The device should not be placed under a

metal surface.

inside the square brackets [ ]:

inside

is a space. The last 11 digit number is

is a space.

space between 6s and no

space

no space

space between

space

Rev: 0813.2MB