celios G200 Посібник користувача - Сторінка 17

Переглянути онлайн або завантажити pdf Посібник користувача для Очищувач повітря celios G200. celios G200 19 сторінок. Advanced air purifier
Також для celios G200: Посібник із швидкого старту (13 сторінок)

Друкувати сторінку

Troubleshooting

Problem

Possible Cause

• Battery(ies) or AC adapter not installed

Unit does not power on

• Battery(ies) installed do not have charge

• Battery(ies) is(are) full

Battery should be charging

• No battery(ies) inserted

• AC adapter not plugged in

• Battery may be at end of life

• Battery may be over temperature limit

• Core Filter not installed properly

Pressure Light AND Warning Light

• Core Filter is loaded

are illuminated AND Beeping is

heard

• General system error (Warning, Pressure,

Unit powered on AND Fan does not

Beep)

operate AND Warning Light flashing

Solution

• Install charged Batteries or connect

to AC adapter

• Replace Batteries with charged ones

or install AC adapter

• The battery light will not display when

full and attached to AC adapter

• Insert 1 or 2 batteries into either slot

• Plug AC adapter into a working outlet

• Install new Battery and recycle old

• Allow the Battery(ies) to cool before

use

• Ensure the Core Filter is fully seated

and latched into the Core

• Remove and discard old Core Filter;

install new Core Filter

• Remove all power sources; install

AC adapter to verify operation; add

Battery(ies)

Problem

Possible Cause

• Error in communications

Remote will not pair

• Core Filter life is very close to zero

Flow is reduced but no Pressure

Warning Light

• Carbon Filter may be depleted

Air exiting the Core has an

unpleasant smell

• Pre Filter may not be seated fully

Core will not fit into the Main Stand

• Battery(ies) may be low

Unit powers on then immediately

powers off

• Filter Life trip point has been met

Filter Life Button flashing AND

Beeping

Solution

• Remove batteries in Remote;

Pressure Light AND Warning Light

are illuminated AND Beeping is heard

remove all power sources from the

Core; reinstall power to the Core then

batteries into the Remote; perform

pairing sequence again

• Replace the Core Filter

• Replace the Carbon Filter

• Press the Pre Filter fully into place

and install the Back Cover

• Charge Battery(ies) with the supplied

AC adapter

• Press the Filter Life Button once to

silence; Filter Life Button will be solid

but no Beep