8STREME 7310 Посібник - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник для Пилосос для басейну 8STREME 7310. 8STREME 7310 16 сторінок. New square swivel
Також для 8STREME 7310: Посібник (3 сторінок), Посібник (18 сторінок)
Друкувати сторінку
EN
- Check the connection of the floating cable.
Disconnect and reconnect as needed.
- Check the status of the connectors at the ends of
your cables (damaged, rusted, etc.)
- Connection of the floating cable
- Possibility of fault of the floating cable
- Possibility of motor leakage
The robot stops after a few minutes
The robot moves slower than before
Red light flashes.
The lights flash one after the other
The red and blue LEDs flash simultaneously
No led lit on the transformer
The robot leaves traces on the floor or on the walls
- The robot is too heavy
- The flow is not sufficient
- Cables connections
- Bad connection
- Possibility of motor problem
- The electrical current does not reach the robot
- The electrical connection is made to the robot, but
the diagnostic system detects a problem.
- No current is coming
- State of the brushes and/or transmission belts
- Check that the dirt collecting basket is not full
- Check and clean if necessary the pump impeller or
the grid above the impeller (propeller at the top
of the robot towards the handle)
- Check all the cable connections (see chapters on
electrical connections).
- Check all the connections of the cables
- Contact the After-sales Service
- Check all the electrical connections (see chapters
on the electrical connections). If moisture is
present on the fittings, let dry before connecting
the fittings again.
- Turn on the switch of the power supply
- Check if the connections are correct and tight.
If the problem persists, please contact your dealer
or our Customer Service at [email protected]
- Check your electrical outlet
- Check the connections
- contact our Customer Service
- These brushes and belts are wear-and-tear parts,
Please check them and change them if necessary
Please contact www.8streme.eu if you have any other questions.
PROBLEM
CAUS E(S)
SOLUTION(S)
Page 12