8STREME 7310 Посібник - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник для Пилосос для басейну 8STREME 7310. 8STREME 7310 16 сторінок. New square swivel
Також для 8STREME 7310: Посібник (3 сторінок), Посібник (18 сторінок)
Друкувати сторінку
EN
4.3 Place your power box to a midpoint between
the two ends of your pool and at least 3.50 m
from the edge of the pool.
4.5 For optimal performance, place your robot in
the pool at the furthest possible location from
the power source.
This is the appropriate length of the cable so
that the robot can reach all of your pool.
Limit the length of cable in the pool to the
bare minimum, and place the surplus outside
the pool.
4.4 Place the robot in your pool and wait until it is
completely submerged. If necessary, help it to
sink manually.
4.6 Connect the power supply to an electrical
outlet nearby. A blue status light should turn
on.
4.7 Press the power button located at the top of
the box to activate your robot.
4.8 To turn off your robot, press the power button
and hold for 3 seconds.
Alternatively, you can also press the switch
located on the side of the box, under blue
light.
4.9 Do not remove your robot out of water
immediately after the end of its cleaning cycle
so as not to cause a temperature shock.
4.10 When the cleaner is no longer used for an
extended period, screw on the protective
cap on the power supply and store your
robot indoors.
* If red or blue lights blink, check the
troubleshooting section
Page 6
Power supply
Rotary coupling
7310 robot