Hifonics BRX1600.1D Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Hifonics BRX1600.1D. Hifonics BRX1600.1D 13 сторінок.

BRX320.4 / BRX640.4 / BRX1200.4 4-CHANNEL AMPLIFIER APPLICATIONS

Front/Rear high pass, using a mono amplifier for mono sub bass

The combination of a mono and a 4 channel amplifier, utilizing their built in

crossovers, makes it a snap to put together a full system with front and rear

highs, with mono sub bass.

Interconnect cable checklist:

- Using good quality RCA cables, feed the front and rear outputs of a head unit to

the inputs of the 4 channel amplifier as shown.

- Also connect the LINE OUT of the 4 channel amplifier to the LINE INPUT of the

mono amplifier as shown.

Mono bass woofer wiring:

Connect the mono speaker positive terminal to the LEFT +, and its negative

terminal to RIGHT -.

Switch setting checklist:

4 channel highs amplifier:

- 1/2CH X-OVER: HI

- 3/4CH X-OVER: HI

BRUTUS

STEREO

INTERCONNECT

RCA CABLE

BRUTUS

Crossover frequency control checklist:

- 4 channel highs amplifier:

Channels 1 / 2 & 3 / 4:

- HI PASS: 100 Hz

- LOW PASS: N/A

Please note that these frequency points are suggestions only. Refer to the

loudspeaker manufacturer specifications and the section "Setting up systems

after installation for best performance"

Level control checklist:

- Refer to the section "Setting up systems after installation for best performance"

Minimum final loudspeaker impedances:

- 2 ohm per channel in stereo mode.

- 4 ohm mono bridged.