Galanz W45A3A401S Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина Galanz W45A3A401S. Galanz W45A3A401S 15 сторінок.
Друкувати сторінку
6. Starting a Washing Programme
Wash cycle table
Cycle Selection
Program
Information
Pre-wash
For the heaviest soiled loads,
Main wash(60℃)
such as pots, pans, casserole
Rinse 1
dishes and dishes that have
Rinse 2
Intensive
been sitting with dried food
Hot rinse
on them for a while.
Drying
Pre-wash
For normally soiled loads,
Eco
Main wash (46℃)
such as pots, plates, glasses
(*E 50242)
N
Rinse
and lightly soiled pans.
(Standard
Hot rinse
standard daily cycle.
Programme)
Drying
Pre-wash
Is optimised according to the
soiled loads,such as pots,
Auto
pans,utensils and cutlery ,
Hot rinse
with the aid of sensors.
Drying
Pre-wash
For lightly and normally soiled
Main wash (60℃)
plates and pans for every day.
Hot rinse
60 min
Drying
A shorter wash for lightly soiled
Main wash(45℃)
loads that do not need drying.
Rapid
Hot rinse
To rinse dishes that you
Pre-wash
plan to wash later that day
Pre-Rinse
EN 50242: this program is the test cycle
The information for comparability test in accordance with EN50242,as follows:
--Capacity: 9 settings
--Position of upper basket: Lower position
--Rinse aid setting: 6 ( or 4 for four setting dispenser)
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the
socket is 12 A 250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press the" Power"
button, Press the " Program? button to select a desired "Wash cycle". (See the section entitled "Wash
Cycle Table") . With a little force to ensure the door is properly closed.
16
Running
Description
Detergent
Energy
Time
of Cycle
Pre/main
(kWh)
(min)
5/22.5
185
1.360
(or 3 in 1)
5/22.5
238
0.782
(or 3 in 1)
Main wash(
40-55℃
)
Rinse
5/22
118-210
0.60-1.10
5/20
60
0.850
15
40
0.65
/
12
0.01
NOTE:
A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing"Power" button.
Change the Programme.
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Water
(L)
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled " Fill in the Detergent " ).
Press?Power? button to cancel the programme, and turn on it again ,then you can change the
14.0
programme to the desired cycle setting (see the section entitled "Starting a wash cycle. . . " ).
NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the display
appears E1. When you close the door, the machine will keep on working after 10 seconds.
8.
The 6 programme lights show the state of the dishwasher:
a) One of the programme lights on--> cycle running
b) One of the programme lights blinking -->pause
NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
6-16
main power and water supply before calling a service.
8.7
Forget to Add Dish
A forgotten dish can be added any time before the detergent cup opens.
1 Open the door a little to stop the washing.
5.9
2 After the spray arms stop working, you can open the door completely.
3 Add forgotten dishes.
3.3
4 Close the door, the dishwasher will work after ten seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears "---" and the buzzer rings 6 times, only in this case the programme
has ended.
1.Switch off the dishwasher by pressing the"Power" button.
2.Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
17