Galanz W60C4A101D-C Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина Galanz W60C4A101D-C. Galanz W60C4A101D-C 13 сторінок.

Друкувати сторінку

6. Starting a Washing Programme

Wash cycle table

Cycle Selection

Program

Information

Pre-wash

For the heaviest soiled

Main wash(60℃)

loads,such as pots, pans,

Rinse1

casseroledishes and

Rinse2

dishes that havebeen

Intensive

Hot rinse

sitting with dried foodon

Drying

them for a while.

Eco

For normally soiled loads,

Pre-wash

Main wash(48 ℃ )

(*E 50242)

such as pots, plates,

(Standard

glassesand lightly soiled

Hot rinse

Programme)

pans.standard daily cycle.

Drying

Pre-wash

Is optimised according to

Main wash(45℃)

the soiled loads,such as

Auto

Rinse

pots,pans,utensils and

Hot rinse

cutlery ,with the aid of

Drying

sensors.

For lightly soiled loads,

Main wash (40 ℃ )

suchas plates, glasses,

Rinse

bowls andlightly soiled

Hot rinse

Crystal

pans.

Drying

A shorter wash for lightly

Main wash (45 ℃ )

soiled loads that do not

Hot rinse

Rapid

need drying.

To rinse dishes that you

Pre-wash

plan to wash later that

Pre-wash

day

Hot rinse 1

For lightly and normally

Hot rinse 2

soiledplates and pans

Hot rinse (50 ℃ )

for everyday

60 min

Drying

50242:this program is the test cycle.

The information for comparability test in accordance with EN 50242,as follows:

Capacity:15 settings

- Position of upper basket :Low position

- Rinse aid setting:6(or 4 for four setting dispenser)

Turning on the Appliance

Starting a wash cycle...

Draw out the lower and upper basket, load the dishes and

1. push them back. It is recommended to load the lower basket first, then the upper one (see the

section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,

Detergent and Rinse Aid").

2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the

socket is 12 A 250 VAC.50 Hz.

Make sure that the water supply is turned on to full pressure. Close the door, press the "Power"

button, press the "program". button to select a desired "Wash cycle". (See the section entitled "Wash

Description

Detergent

Running

Energy

of Cycle

Pre/main

Time(min)

(kWh)

5/32.5

213

1.680

(Or 3in1)

5/32.5

234

0.836

(Or 3in1)

0.930-

5/30

140-228

1.950

5/20

124

0.800

0.600

0.010

1.050

5/20

2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the

socket is 12 A 250 VAC.50 Hz.

Make sure that the water supply is turned on to full pressure. Open the door, press the ON/OFF

button, Press the "program." button to select a desired "Wash cycle". (See the section entitled "Wash

Cycle Table") . With a little force to ensure the door is properly closed.

Water

(L)

NOTE:

A click could be heard when the door is closed perfectly.

When the washing is over, you can shut off the switch by pressing ON/OFF button.

Change the Programme.

15.3

Premise: A cycle that is underway can only be modified if it has only been running for a short time.

Otherwise, the detergent may have already been released, and the appliance may have already

drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section

entitled " Fill in the Detergent " ).

Open the door, Press current prog. button more than three seconds to cancel the programme, then

10.0

you can change the programme to the desired cycle setting (see the section entitled "Starting a wash

cycle. . . " ). Then, close the door.

NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the display

appears E1. When you close the door, the machine will keep on working after 10 seconds.

6.5-18

The 6 programme lights show the state of the dishwasher:

a) All program lights off --> stand by

b) One of the program lights on --> cycle running

c) One of the program lights blinking --> pause

9.5

NOTE:

If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the

main power and water supply before calling a service.

6.6

Forget to Add Dish

A forgotten dish can be added any time before the detergent cup opens.

1 Open the door a little to stop the washing.

3.9

2 After the spray arms stop working, you can open the door completely.

3 Add forgotten dishes.

4 Close the door, the dishwasher will work after ten seconds.

9.6

WARNING!

It is dangerous to open the door when washing, because the hot water may scald you.

Switch Off the Dishwasher

The digital display appears "---" and the buzzer rings 6 times, only in this case the programme

has ended.

1.Switch off the dishwasher by pressing the ON/OFF button.

2.Turn off the water tap!

Open the door carefully. Hot steam may escape when the door is opened!

■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around

15 minutes before removing from the appliance.

■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In

this way they will be cooler and the drying will be improved.

Unloading the dishwasher

It is normal that the dishwasher is wet inside.

Empty the lower basket first and then the upper one. This will avoid water dripping from the upper

basket onto the dishes in the lower one.