dBTechnologies FlexSys FMX10 Посібник користувача "Швидкий старт - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача "Швидкий старт для Акустична система dBTechnologies FlexSys FMX10. dBTechnologies FlexSys FMX10 4 сторінки. Section 1

Technical Data
Speaker
Type:
Coaxial Active Stage Monitor
Usable Bandwidth [-10
dB]:
Frequency Response [-6
dB]:
Max SPL (1
m):
125 dB
HF compression
driver:
1 " Exit
HF voice
coil:
1"
LF:
10"
LF Voice
Coil:
2"
Crossover
frequency:
1800 Hz (24 dB/oct)
Horizontal
dispersion: 60° (rotatable horn)
Vertical
dispersion: 90° (rotatable
Amplifier
PSU
Technology:
SMPS
Amp
Class:
Class-D
RMS
Power:
400 W
Operating voltage (
factory internal setup
220-240V~ (50-60Hz) or
100-120V~ (50-60 Hz)
Scan with your QR Reader
App to download the
complete User Manual
EMI CLASSIFICATION
According to the standards EN 55032 and EN 55035 this equipment is designed and suitable to operate in class B electromagnetic
environments.
FCC CLASS B STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not cause harmful
interference,and (2)this device must accept any interference received,including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
WARNING: Make sure that the loudspeaker is securely installed in a stable position to avoid any injuries or damages to persons or properties.
For safety reasons do not place one loudspeaker on top of another without proper fastening systems. Before hanging the loudspeaker check
all the components for damages, deformations, missing or damaged parts that may compromise safety during installation. If you use the
loudspeakers outdoor avoid spots exposed to bad weather conditions.
Contact dB Technologies for accessories to be used with speakers. dBTechnologies will not accept any responsibility for damages caused by
inappropriate accessories or additional devices.
Features, specification and appearance of products are subject to change without notice.dBTechnologies reserves the right to make
changes or improvements in design or manufacturing without assuming any obligation to change or improve products previously
manufactured.
FMX 10
57 – 19000 Hz
65 – 16500 Hz
horn)
):
www.dbtechnologies.com
Processor and user interface
Controller:
28/56 bit DSP
AD/DA
Conversion: 24 bit - 48 kHz
Limiter:
Peak, thermal, RMS
Controls: DSP programs rotary encoder, Line/Mic switch,
Input Sensitivity level
Input / Output
Mains
connections:
Signal
Inputs:
1 x balanced XLR connector
Signal
Out/Link:
Mechanics
Housing:
Wooden Box
Grille:
Full metal grille
Pole Mount
Hole:
Width:
390 mm (15.35 in)
Height:
268 mm (10.55 in)
Depth:
411 mm (16.18 in)
Weight: 11.3
kg (24.9 lbs)
Download the complete user manual from the site:
www.dbtechnologies.com/EN/Downloads.aspx
measures:
VDE
1 x balanced XLR connector
Yes, 36 mm
Rev 1.2 cod. 420120314Q